UT903611 Homelite Generator - Overview

This inline fuel filter is a genuine OEM part designed for use with pressure washers and generators and is sold as an individual part. Made of plastic, this filter is used to prevent dirt and debris from entering the carburetor and engine of your equipment. Regular maintenance, routine inspections, and replacement of this part will help t...Read moreo prevent any issues with your equipment in the future and ensure best performance. If your equipment is experiencing starting issues or you notice blue or dark-colored smoke coming from your equipment, the filter may need to be replaced. To replace your current filter, gain access to the fuel line or tank, restrict the flow of fuel through the filter, and simply remove it before replacing it. If your filter needs replacing, check your fuel lines for any clogs or debris build-up.

This fuel shut-off valve, also known as a fuel valve or fuel selector valve, is an OEM replacement part designed for use in generators. The valve controls the flow of fuel to the engine. When the valve is in the on position, fuel flows to the engine, enabling it to run. When the valve is in the off position the flow of fuel stops and the ...Read moregenerator shuts down. Over time the valve may become clogged or damaged, and unable to fully close or open. Once the fuel shut off valve is no longer functioning, the generator will leak fuel, and may have difficulty in starting or running. Before replacing the valve, first disconnect the fuel line and place a container below the fuel tank to allow the fuel to drain out. Detach the old fuel shut off valve and install the new one in its place. Apply thread sealant to the new valve for a good seal and reattach the fuel line. Refill your tank with fresh fuel and run the equipment to ensure there are no more leakages.

This OEM replacement washer is a thin, flat, round-shaped metal disk with a hole in the center, used in a variety of outdoor power equipment. It is made of steel and has an inner diameter of 0.25 inches. Washers are designed for use with fasteners such as bolts or screws to distribute the clamping force of the fastener and provide additio...Read morenal security to the parts being fastened. Additionally, they protect the surface they are positioned on from damage and can be used to align/level various components. You will need to replace your washer if it is corroded, cracked, or worn down. Each washer is sold individually.

This replacement part is specially designed for use with Homelite generators. The capacitor is a two terminal electrical device used to store electrical energy in the form of electric field. It basically provides leading current in AC circuits. In a DC circuit, the capacitor once charged with the applied voltage acts as an open switch. Please note it is sold individually.

This is an authentic Homelite replacement part. The outlet cover is designed by the manufacturer for use in portable generators. This part is made of flexible rubber, and is attached to the cover plate to protect the duplex receptacle outlets when not in use. You will require a screwdriver when replacing this part. This item is sold individually.

This special wheel is sourced from the original manufacturer to be used with Homelite generators, it is not an aftermarket imitation part. The special wheel is a complete replacement part that includes the tire, rim, and bearings. This wheel is available as an individual replacement part, please note two are required. See illustrated part list for related parts like the bolts, nuts, washers, and spacers.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Ridgid, Homelite and Husky generators. It provides an identical replacement for a missing or a faulty fuel tank bushing that was installed on a new unit. This is one of the special bushing utilized to mount the fuel tank. Please make sure ...Read moreto refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality bushing is made of durable rubber with metal and is sold individually.