UT43122 Homelite Chainsaw - Overview

This is a genuine OEM replacement part, it is sold individually. The purpose of the 3290875G Retaining Ring is to attach and hold the washer and sprocket to the driveshaft on the models shown below. To remove this part it is best to use retaining ring pliers (or snap ring pliers).

This is a genuine OEM replacement part, it is sold individually. The purpose of this washer is to act as a spacer between the chain sprocket and as a friction barrier on the chainsaw models shown below. This is a wear part that we send out quite often. It is advised to order an extra one or two to keep on hand.

Genuine Craftsman replacement part, this item is sold individually. Chainsaws use sprockets to engage and spin the chain. When it wears down, your saw will see a sharp decrease in performance. A worn sprocket may cause the chain to slip or not spin at all, and when this happens, you will want to replace it.

It is a genuine item that is supplied by the original equipment manufacturer for use with The Safe-T-Tip-« Anti-Kickback Nose Guard is an attachment provided on the end of the guide bar to prevent the chain on the end of the guide bar from contacting the wood. It provides an identical replacement for a missing or a faulty component that w...Read moreas included with a new unit. Please make sure to refer to the owners manual for the correct application of this part. Keep in mind this high-quality Safe-T-Tip is made of durable metal and is sold individually.

If you are replacing the original ring gear part # 34118154G, you will need part # 31105573G and 33902102-1G to replace it.

It is an authentic OEM supplied hardware that is designed for use with Homelite and Ryobi chainsaws. This special screw is used to secure the Safe-T-Tip to the bar. Please note this high quality hex head screw with a washer is sold individually, you will need a wrench to secure or remove it.

This is a manufacturer approved replacement guide bar designed for Homelite chainsaws. The purpose of a bar is to hold the cutting chain. Having a bent or damaged bar is extremely dangerous and it should be replaced immediately. Guide bar is made out of metal and it is sold individually. Designed to accommodate for a 16" chain only. You...Read more would need a screwdriver a wrench set to replace this part. • Remove the housing • Release the chain tension • Remove the chain and the tensioner • Remove the bar and replace it with a new one • Secure the tensioner and the chain • Reassemble the housing and tighten the chain

This is an Authentic Manufacturer Sourced replacement part designed for use with Homelite Chainsaws. If the chainsaw bar doesn't adjust, usually the tension adjustment bolt is worn or damaged. This part is made out of Metal and it is Sold Individually.

This item is available as an individual replacement part. The housing is made of plastic. It may require a screwdriver and a set of pliers during installation. Over time this item may break and will need to be replaced. It is a genuine OEM sourced part which is specially designed for use with Homelite chain saws.

This adjustment knob with insert is specially designed for Homelite electric chainsaws. It is supplied directly from original equipment manufacturer and it is sold individually. It is the knob that allows user to adjust chain tension. This includes a plastic knob, insert, washer and a screw. Please note to replace this adjustment knob you will need a screwdriver.

A genuine item which is supplied directly from the original equipment manufacturer for use with Homelite electric chainsaws. It is an identical replacement for a missing or damaged power cord which was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and applicat...Read moreion of this hardware. Keep in mind this high-quality rubber insulated cord is sold individually.