UT43120A Homelite Chainsaw - Overview

This is a genuine OEM replacement part, it is sold individually. The purpose of this washer is to act as a spacer between the chain sprocket and as a friction barrier on the chainsaw models shown below. This is a wear part that we send out quite often. It is advised to order an extra one or two to keep on hand.

Genuine Craftsman replacement part, this item is sold individually. Chainsaws use sprockets to engage and spin the chain. When it wears down, your saw will see a sharp decrease in performance. A worn sprocket may cause the chain to slip or not spin at all, and when this happens, you will want to replace it.

It is a genuine item that is supplied by the original equipment manufacturer for use with The Safe-T-Tip-« Anti-Kickback Nose Guard is an attachment provided on the end of the guide bar to prevent the chain on the end of the guide bar from contacting the wood. It provides an identical replacement for a missing or a faulty component that w...Read moreas included with a new unit. Please make sure to refer to the owners manual for the correct application of this part. Keep in mind this high-quality Safe-T-Tip is made of durable metal and is sold individually.

It is an authentic OEM supplied hardware that is designed for use with Homelite and Ryobi chainsaws. This special screw is used to secure the Safe-T-Tip to the bar. Please note this high quality hex head screw with a washer is sold individually, you will need a wrench to secure or remove it.

This is a manufacturer approved replacement guide bar designed for Homelite chainsaws. The purpose of a bar is to hold the cutting chain. Having a bent or damaged bar is extremely dangerous and it should be replaced immediately. Guide bar is made out of metal and it is sold individually. Designed to accommodate for a 16" chain only. You...Read more would need a screwdriver a wrench set to replace this part. • Remove the housing • Release the chain tension • Remove the chain and the tensioner • Remove the bar and replace it with a new one • Secure the tensioner and the chain • Reassemble the housing and tighten the chain

Genuine Homelite replacement part, this item is sold individually. This Retaining Ring is used to secure the Chainsaw Sprocket and Washer on the drive shaft on the Chainsaws listed below. This item has a tendency to wear, it may be wise to order an extra one.

It is a genuine manufacturer-supplied replacement part that is supplied for use with Homelite chainsaws. This special cap is used to keep the oil in the reservoir, it includes the rubber gasket to ensure a tight seal. It is a durable component which is made of high-quality plastic and it is sold individually.

This is genuine manufacturer sourced replacement part. It is specially made for use with Homelite chainsaws. The chain plays a key function because it is what directly cuts the material. Over time chains have a tendency to stretch, become dull or break requiring replacement. This 16 inch chain is made out of metal and it is sold individua...Read morelly. To replace this item you will need a wrench set and a screwdriver. • Make sure the too is not powered • First you want to remove the guide bar side panel • Release the chain tension • Remove the old chain • Loosen the tension screw • Thread the new chain onto the saw • Align the guide bar • Replace the side plate • Tighten the chain to the correct tension • Finish tightening the side plate nuts