UT26CSL3VNM (095330107) Homelite Trimmer - Overview

This authentic OEM starter rope measures 42-inches and is for use with various models of outdoor power equipment. Made of nylon, this rope wraps around the starter recoil spring and when pulled, is used to start the engine. This rope is sold as an individual part, so any necessary grips are sold separately.

This OEM spring, also known as a recoil or rewind spring, is housed in a container and is used to retract the starter rope on various lawn equipment models. Over time and through use, the spring will eventually lose its tension, and will break. If your starter rope has no resistance when pulling it, the starter spring is likely broken. Me...Read moreasuring at approx. 3-inches by 3-inches, this spring is suitable for use with a variety of lawn equipment models and is sold individually.

This OEM switch is used on a variety of different lawn equipment models and is sold individually. This switch is used to turn your lawn equipment on and off, so if your equipment is either not turning on, or this switch feels loose within its housing, it may be time to replace it. To remove it, separate the two halves of the housing which...Read more it connects to, disconnect the throttle and other wires with pliers, and depress the securing tabs. To install the new switch, click it into place within the housing and connect the appropriate wires to the two terminals, and then reconnect the throttle cable and other wires, and then simply align the two halves of the housing and secure with screws.

This replacement ignition module is a high quality item designed for use with Ryobi gas powered blowers and vacuums. This ignition module also known as an armature magneto produces pulses of high voltage for the spark plugs. It is made out of metal with rubberized wire and the spark plug boot. To complete this repair you will need a screwdriver set.

This spring is a genuine OEM replacement part supplied directly from the manufacturer. It is designed for use in various models of Ryobi string trimmers. This coil type compression spring is placed inside the string head housing. It is made of metal and sold individually.

This is an OEM sourced replacement part used on gas trimmers. A centrifugal clutch is a part that uses centrifugal force to connect two concentric shafts, with the driving shaft nested inside the driven shaft. Today's centrifugal clutches will function even when they shouldn't, far beyond the point of when they need to be replaced. Keepin...Read moreg an eye on equipment performance will determine when the centrifugal clutch requires attention. Please note the clutch drum, spacer and washer are all sold separately. This clutch is made out of metal and it is sold individually. To replace this item you would need a screwdriver and pliers.

Genuine OEM replacement part, this item is sold individually. The purpose of the 901551001 Intake Gasket is to create a seal between the Heat Dam and the cylinder head. Over time because of the heat it is exposed to this gasket will deteriorate and will have to be replaced.

This replacement screw is a high-quality hardware that is supplied by the original equipment manufacturer for use with Homelite and Ryobi handheld lawn and garden equipment. It is a standard hardware which will have multiple applications depending on the model of your unit, please make sure to check the appropriate diagrams for the correc...Read moret location and use of this part. Keep in mind this screw is made of durable metal and is sold individually.