UT-20818 Homelite Trimmer - Overview

This is a genuine OEM replacement part, sold individually. This Bumper helps keep the fuel tank in place, and minimizes vibration of the fuel tank. This part is used with a variety of string trimmers, compatible with the models listed below.

Springs are used within outdoor power equipment to provide tension and shock absorption, depending on their application and use. This spring is designed for use within trimmers/brush cutters and is made to provide tension on the spool reel mechanism, and in some cases may be used to advance the line whenever portions of it are cut off. Th...Read moreis spring measures approximately 1.3-inches in length when extended and comes as an individual part. If you notice the line/spool in your trimmer is not advancing or is coming too quickly, the spring may be damaged and need replacing. Since this spring is a high-use part, it is not uncommon for it to lose tension over time and need to be replaced. To replace the spring, you will need to unscrew the covering cap, remove the spool feeding reel, remove the old spring and install the new spring with the rest of the assembly. Make sure to feed the line back into the appropriate feeding holes prior to operation of the trimmer.

This is an OEM replacement part and is sold individually. Its purpose is to filter out dust and debris from contaminating the carburetor. When replacing the filter you can open the package in comes in and put a bit of two cycle oil in the bag and let it absorb into the filter. Then remove it from the bag and squeeze it with a paper towe...Read morel to remove the excess oil. This will aid the filter in filtering out the unwantables.

Throttle Cable with a 11" Conduit. For a 15" conduit see Related Item.

This gasket sits between the heat dam and the carburetor helping to provide and air tight seal between the two connected parts. It is an authentic manufacturer sourced replacement part that is specially designed for use with Ryobi handled lawn and garden equipment. Over time gaskets tend to get compressed and deteriorate eventually requir...Read moreing replacement. It is made from durable composite material and it is sold individually.

This is a genuine OEM approved component which is specially designed for use with Homelite and Ryobi handheld lawn and garden equipment. It provides an identical replacement for a missing or a faulty hardware that was installed on a new unit. Keep in mind this high-quality screw is made of durable metal and is sold individually. It is a s...Read moreelf-tapping screw that will form threads in the material it is being driven into. Make sure to refer to the owners manual and the appropriate diagrams of your model for the correct location and application of this part.

This is a genuine OEM sourced replacement part that is intended to be used with trimmers and pruners from Homelite and Ryobi. The metal screw is commonly used to fasten the muffler assembly to the cylinder's exhaust port. This screw is priced as a single item, please note two screws may be needed.

This starter pulley is an OEM part direct from Ryobi. This part is compatible with a variety of lawn and garden devices. The pulley is most often fitted between the air baffle and the container w/spring within the starter assembly. Please consult specific manual and diagrams for repair instructions. This part is sold individually. A screwdriver and a hex key are usually needed in making the replacement.