UAN6507E Frigidaire Washer - Overview

Diagrams for UAN6507E

See every part. Know exactly what you need.

Parts for the UAN6507E

$117.66

Water Inlet Valve

★★★★★

(12)

Part #134190200

The water inlet valve has two ports for water to enter and controls the flow of water into a washing machine. Hot, cold, and warm water can easily enter the washer this way. If the water inlet valve is in any way damaged or defective, it may be slow to fill or even leak. Before beginning this replacement, make sure to unplug the washer fr...Read more

Read less

BELT

Part #144667

SPACER

Part #5308015493

This spacer is used in washers or a washer and dryer combo unit. Spacers are used to create space between cotter pins, lock nuts, hitch pins or to fill the space between machinery parts in a washer. This part goes between the timer knob and the dial in a washer to function effectively and provide protection. The length of this part is 6.3...Read more

Read less

SNUBBER RING

Part #WH1X2312

TRUNNION

Part #131545101

This part helps with the spinning and agitating cycles.

$742.52

Transmission Assembly

Part #134736400

This part aids in the spinning and agitating cycles. The length of the shaft on this part is 13". The seal/gaskets are NOT included.

Water Temperature Switch

Part #5308014346

CAP-AGITATOR

Part #5303161122

$34.38

PULLEY

Part #5304527822

Motor and Drain Pump Assembly

Part #131027600

Motor is 120 volts.

$46.34

Rotary Knob - Stainless Steel

Part #5308008462

CAPACITOR

Part #131212302

Common Symptoms of the UAN6507E

How this model fails, and the parts that fix it.

Videos related to the UAN6507E

Watch our pros, then fix it yourself.

Replacing the Water Inlet Valve

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Washer Continued To Fill To Point Of Overflow

86 of 97 people found this instruction helpful.

alvaro from east hampton, NY
Really Easy
Less than 15 mins
Pliers, Screw drivers

First I removed the top panel held by four screws at rear of panel, pulling the panel foward and up. Then disconnected the power and water connections. Then I removed the two screws holding the flow valve to the washer rear panel,pulled the valve foward ,removed the two electric connectors, pinched the water clamp with pliers and remo ... Read more

Read less

Was this helpful?

No Cold Water

17 of 19 people found this instruction helpful.

Mark from Pittsburgh, PA
Really Easy
15 - 30 mins
Pliers, Screw drivers

Checked problem on-line and discovered it was the water inlet valve. Matched the part on part select. Com. Finding the part was very easy. Part select had a grid behind the picture to help determine the size and pictures from all sides. Removing the old part, matching it, and replacement took a total of 30 minutes. I now have cl ... Read more

Read less

Was this helpful?

belt worn causing machine to make all kinds of noise

19 of 26 people found this instruction helpful.

Kenneth from Baltimore, MD
A Bit Difficult
30 - 60 mins
Screw drivers

pull up on top ,take two screws loose on front panel(pull off) vaccum old debri out,pull tension pulley back pull old belt off,holding tension pulley put new belt on .put front panel back on and snap top back down to secure.
working perfectly nice and quite !!!

Was this helpful?