UAN6506-87C Frigidaire Washer - Overview

Diagrams for UAN6506-87C

See every part. Know exactly what you need.

Parts for the UAN6506-87C

$26.35

Screw-In Plastic Leveling Leg

★★★★★

(4)

Part #134548800

This is a screw in leveling leg for your washing machine. It supports the appliance by screwing in place to create a stable and flat surface. Take note that you are able to adjust the height of your appliance to make it leveled. This model is made entirely of plastic and is white in color. It is just under 2.5 inches long, 1.5 inches wide, and the head has a diameter of roughly 1.5 inches.

BELT

Part #144667

SPACER

Part #5308015493

This spacer is used in washers or a washer and dryer combo unit. Spacers are used to create space between cotter pins, lock nuts, hitch pins or to fill the space between machinery parts in a washer. This part goes between the timer knob and the dial in a washer to function effectively and provide protection. The length of this part is 6.3...Read more

Read less

SNUBBER RING

Part #WH1X2312

TRUNNION

Part #131545101

This part helps with the spinning and agitating cycles.

$742.52

Transmission Assembly

Part #134736400

This part aids in the spinning and agitating cycles. The length of the shaft on this part is 13". The seal/gaskets are NOT included.

Water Temperature Switch

Part #5308014346

$34.38

PULLEY

Part #5304527822

Motor and Drain Pump Assembly

Part #131027600

Motor is 120 volts.

$46.34

Rotary Knob - Stainless Steel

Part #5308008462

CAPACITOR

Part #131212302

$29.47

SPRING

Part #5303212125

Common Symptoms of the UAN6506-87C

How this model fails, and the parts that fix it.

Videos related to models starting with UAN6506-87C

Watch our pros, then fix it yourself.

Replacing the Washer Drain Hose

Replacing the Screw-In Plastic Leveling Leg

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

belt worn causing machine to make all kinds of noise

19 of 26 people found this instruction helpful.

Kenneth from Baltimore, MD
A Bit Difficult
30 - 60 mins
Screw drivers

pull up on top ,take two screws loose on front panel(pull off) vaccum old debri out,pull tension pulley back pull old belt off,holding tension pulley put new belt on .put front panel back on and snap top back down to secure.
working perfectly nice and quite !!!

Was this helpful?

The front level screw legs are made of plastic and each time I move they break

5 of 5 people found this instruction helpful.

Bobby from Asheboro, NC
Really Easy
15 - 30 mins
Wrench (Adjustable)

screwed in the new legs and leveled it off again.

Was this helpful?

drive belt replacement

5 of 6 people found this instruction helpful.

Scott from Cumming, GA
A Bit Difficult
30 - 60 mins
Pliers, Screw drivers, Socket set

removed rear panel, tilted machine forward, removed four bolts holding the pump and loosened the connection to the motor shaft,(several times dropped socket and without magnet to retrieve tools would have been much more difficult),removed two hoses, dropped pump assembly, replaced belt, and reversed the process to re-assemble. Easy to fin ... Read more

Read less

Was this helpful?