TW1000 Makita Impact Driver - Overview

This power cord is for power tools. Unplug the power tool before installing this part. Wear work gloves to protect your hands.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

This is a genuine Makita replacement part that includes two carbon brushes with wire leads attached. Carbon brushes are essential components in power tools and are among the most commonly replaced parts due to regular wear from friction. Over time, worn brushes can cause a motor to run poorly, operate intermittently, or lose electric brak...Read moreing power. Replacing them can often restore your tool’s performance. A worn brush may appear cracked, pitted, burned, or worn down near the wire lead. It’s always best to replace both brushes at the same time, even if only one shows signs of wear. When installing new brushes, be sure to inspect the armature for any damage such as burns or cracks, which could indicate more serious motor issues.

This genuine OEM steel ball is found within the housing of your power tool. It serves as a detent mechanism, securing the shift knob in various positions to allow for the selection of different operating modes. It has a diameter of 4.8mm. If you notice signs of wear or deformation on the steel ball, it is a clear indication that it needs ...Read moreto be replaced. A worn-out steel ball can result in a loose shift knob that fails to hold its selected position properly. To locate and access the steel ball within the housing, refer to the instructions outlined in your user manual. Your tool may use steel balls of different sizes, so confirm that this is the correct part your repair will need before making your purchase.

Genuine Makita replacement part, this item is sold individually. The purpose of the Brush Holder Cap is to retain the brush in the brush holder. This Brush Cap is used on all the Makita models listed below. It is removed by using a slotted screwdriver Do not press too hard when removing the cap they do have a tendency to break.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Makita power tools. It is an identical replacement for a missing or damaged rubber pin that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and applicat...Read moreion of this hardware. Keep in mind this high-quality item is made of durable rubber material and is sold individually.

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutters. The washer has multiple applications based on the model of the power tool. It is recommended to review your model's diagram to verify this washer's compatibility. The washer is sold individually.

This is an authentic Makita replacement part manufactured for use with angle grinders and circular saws. The sealed bearing is used to reduce friction between a rotating shaft and fixed housing or assembly. This bearing is often used to allow the spindle to rotate inside the gear box, but may have other uses. Please see model diagram for part location and usage. This bearing is sold individually.