TRT17CRAW0 Tappan Refrigerator Parts & Repair Help | PartSelect
Models > TRT17CRAW0

TRT17CRAW0 Tappan Refrigerator - Overview

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
(34)
PartSelect #:PS423801
Manufacturer #:215846602
This Defrost Timer works like a clock by switching on the defrost heater circuit after a predetermined amount of compressor run time. This allows the defrost circuit to clear the e...
$24.27
In Stock
(4)
PartSelect #:PS447375
Manufacturer #:3206150
This white end cap is a little over two inches long. It is used for the right side of either the refrigerator of the freezer door shelf.
No Longer Available
(3)
PartSelect #:PS467739
Manufacturer #:5303324302
This is the door shelf end cap for your refrigerator. It connects to the refrigerator door and keeps the door bar in place. Your refrigerator will have two shelf end caps, one for ...
$10.85
In Stock
(2)
PartSelect #:PS422630
Manufacturer #:215366002
This is a white cut-to-fit door shelf retainer bar.
$49.47
In Stock
(8)
PartSelect #:PS2333670
Manufacturer #:5304464438
The run capacitor helps the compressor kick on and off while maintaining a constant temperature in your fridge and freezer. You may need to replace your run capacitor if your refri...
$34.96
In Stock
(7)
PartSelect #:PS469269
Manufacturer #:5303917954
This limiter thermostat cuts out when the temperature inside your refrigerator reaches 55 degrees Fahrenheit and kicks back in when the internal temperature drops to 20 degrees Fah...
$24.87
In Stock
(8)
PartSelect #:PS12751166
Manufacturer #:316538904
Clear, 120 Volt, 40 Watt.
$12.19
In Stock
PartSelect #:PS447389
Manufacturer #:3206165
This is the door shelf end cap for your refrigerator. It connects to the refrigerator door and keeps the door bar in place. Your refrigerator will have two shelf end caps, one for ...
No Longer Available
(3)
PartSelect #:PS447390
Manufacturer #:3206166
This is the door shelf end cap for your refrigerator. It connects to the refrigerator door and keeps the door bar in place. Your refrigerator will have two shelf end caps, one for ...
$9.50
In Stock
(6)
PartSelect #:PS450319
Manufacturer #:5300158289
The evaporator fan motor kit is specifically made for your refrigerator to run the evaporator fan in your refrigerator. It is mounted on the center hub and has three lead wire term...
$62.49
In Stock
Questions and Answers for TRT17CRAW0
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Fridge got warm and freezer coils were frosted

  • Customer: Stephen from Warrington, PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 328 of 389 people found this instruction helpful
Fridge is a side by side. The freezer is pretty narrow for a guy with wide shoulders.

Pulled plug.

Had to remove bottom drawers then used nut driver to remove screws closest to back wall in drawer runners. Once the back screws were removed the runners could be swung up or down out of way so back cover could be removed.

On... read more

Noisy fan

  • Customer: Jordan from Maumee, OH
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 144 of 166 people found this instruction helpful
1. Removed the 7 nuts using the nut driver from the freezer back panel inside the freezer.
2. Remove the back panel. The evaporator motor and fan are located above the coils.
3. Unplug the wiring harness.
4. Remove the two gold mounting screws holding the motor and fan in place.
5. Remove the motor and fan including the brackets.
6. ... read more

Clicking sound then within a minute clicking again, not cooling.

  • Customer: Melvin from Semmes, AL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 79 of 91 people found this instruction helpful
UNPLUG REFRIGERATOR. Carefully remove relay from the side of the compressor. You shouldn't need a tool to do this, if it is hard you can gently pry the edge with a flat head screw driver just to loosen. Unplug white and red wires from relay, noting that the white wire goes in the hole with a #2 stamped beside it. Shake old relay, if it rattles like a baby r... read more