TGC3X4XCD1 Tappan Cooktop - Overview

Diagrams for TGC3X4XCD1

See every part. Know exactly what you need.

Parts for the TGC3X4XCD1

$34.15

Surface Burner Igniter Electrode

★★★★★

(4)

Part #316011200

Use this igniter with sealed burners.

$7.65

Top Burner Mounting Screw with Washer

Part #316069301

This is now a new zinc and black-coated screw that will resist rust and seizing.

$59.17

MODULE

★★★★★

(2)

Part #5304505695

Burner Grate

Part #5303272852

Sold Individually.

Igniter Switch

Part #316032002

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.

$76.97

Burner Trim Ring - Small

Part #316011300

Bushing

Part #318146301

Screw

Part #316011100

$205.43

Gas Pressure Regulator

Part #5308007974

***No Conversion Kit Required - Adjust On Appliance*** This valve automatically cuts off the flow of a liquid or gas when it reaches a certain pressure.

CAP-BURNER

Part #316011014

VALVE

Part #5303935042

$73.04

Knob - Black

Part #318016205

Sold individually.

Common Symptoms of the TGC3X4XCD1

How this model fails, and the parts that fix it.

Will Not Start

Fixed by
these parts

Show All

Gas igniter glows, but will not light

Fixed by
these parts

Show All

Element will not heat

Fixed by
these parts

Show All

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Igniter porcelain was cracked and burner would not light.

53 of 76 people found this instruction helpful.

Rusty from Howell, NJ
Easy
15 - 30 mins
Screw drivers

un-pluged stove,removed the one screw holding the broken igniter. disconected the one wire. installed new igniter and slipped on wire. The igniter came with a new bracket, the old one rusted away which is why the old igniter broke.

Was this helpful?

Bad igniter.

16 of 18 people found this instruction helpful.

chris from Venice, CA
A Bit Difficult
1- 2 hours
Nutdriver, Pliers, Screw drivers, Wrench set

The stove was older so the burner was hard to get out. The small screw heads broke off, so I had to carefully center punch and drill out the screw bodies. The igniter screw was also frozen in the pot metal burner. That screw requied drilling and tapping with the installation of a new 6-32 screw. Once the burner was refurbished, the igni ... Read more

Read less

Was this helpful?

burner would not lite

12 of 16 people found this instruction helpful.

Terry from Wilkinson, IN
Really Easy
Less than 15 mins
Screw drivers

no need to remover burner. Lift top up use a 1x4x5" to hold top up. Use short #2 screw driver remove screw and replace with new igniter

Was this helpful?