TBE252 (41ADE252766) Troy-Bilt Edger - Overview

This is a genuine manufacturer approved replacement drive shaft that is designed for string trimmers. Flexible drive shaft fits inside the drive shaft housing to spin the cutting head. It is made out of metal and it is sold individually. To complete this repair you would need a screwdriver and pliers. Removing the Drive Shaft: • Loos...Read moreen the shaft screws. • Remove the air filter. • Remove the throttle cable. • Remove the ignition wires. • Remove the shaft housing. • Remove the drive shaft. Installing the New Drive Shaft: • Lubricate the drive shaft. • Install the new drive shaft. • Re-install the shaft housing. • Re-install the throttle cable and ignition wires. • Re-install the air filter assembly.

This genuine OEM throttle trigger allows you to control the engine speed of your trimmer by squeezing or releasing it, which engages the throttle cable. It is conveniently located on the handle assembly for easy access during operation. If you experience stickiness, looseness, or unresponsiveness, the throttle trigger is faulty and requir...Read morees replacement. A malfunctioning throttle trigger makes it difficult to control the engine speed, leading to challenges in starting the trimmer, maintaining a consistent speed, or adjusting power as needed. To replace the throttle trigger, you will need a screwdriver with a Torx bit. First, remove the fasteners holding the throttle housing, then separate the two halves of the housing. Disconnect the lever from the throttle cable and remove it, along with the spring, from your trimmer. Please note that the throttle trigger is sold separately from the throttle cable and spring.

This part is an OEM sourced directly from the manufacturer. It is designed for blowers, trimmers, and edgers made by Troy-Bilt, Ryobi, Yard Man, MTD, and Cub Cadet. The metal star screw fits into various parts and will require a Torx screwdriver. It will need to be replaced if it becomes lost or stripped. This screw is available as an individual replacement part even though many might be needed.

This is a genuine manufacturer-sourced component which is specially produced for use with Troy-Bilt, Yard Man and MTD handheld string trimmers. It is an identical replacement for a missing or a faulty spring that was installed on a new unit. The purpose of this hardware is to apply tension on the throttle trigger. Please make sure to refe...Read morer to the appropriate diagrams of your model for the correct location and application of this part. Keep in mind it is a high-quality spring is made of durable metal and is sold individually.