SQS55XP15GA (660101N) Senco Nailer - Overview

This is a genuine Senco replacement part, it is sold individually. Its purpose is to retain or secure the Retaining Pins in the Senco models below. It is attached to the pins by pressing them on the beveled end of the pins.

This is a Genuine OEM replacement part for use with Senco Nailers/Staplers. This item is made out of Rubber Material and it is Sold Individually. The purpose of this part is to create a seal so air does not leak from the gun. When replacing this Seal it is advised to inspect all of the other Seals and O-Rings for wear. When replacing this item you would need an Allen Wrench Set and Pliers.

This is an authentic replacement part manufactured for use with Senco pneumatic nailers and staplers. The special spring is commonly used to provide resistance for the single sequential type of trigger assembly. This spring is available as an individual replacement part.

This spring is an OEM part direct from Senco. The metal spring is compatible with several nailer devices, and is sold individually. This component provides the necessary resistance in the trigger. Pliers and a hex key are often required for the installation.

This authentic item is sourced directly from the original equipment manufacturer for use with Senco framing nailers. It is one of the special pins utilized to secure the cover for the trigger. The pin fits into the housing and is secured in place by a retainer which is sold separately. It provides a high-quality replacement for a missing ...Read moreor a damaged component that was installed on a new unit. To ensure the correct installation, refer to the appropriate diagram of your model. You will need pliers to remove and secure this hardware. NOte, one durable metal pin is included.

This is an Authentic OEM replacement part for use with Senco Nailers/Staplers. This item is made out of Rubber and it is Sold Individually. The purpose of this part is to create a seal so air does not leak from the gun. When replacing this Seal it is advised to inspect all of the other Seals and O-Rings for wear. When replacing this item you would need an Allen Wrench Set and Pliers.

This is an original part from Senco. The bumper is made for use with several heavy wire staplers, and is sold individually. The bumper is constructed of poly plastic, and is fitted between seals in the body assembly. This item assists with securing the piston, and a hex key is required for the proper repair.

This is an authentic replacement part manufactured for Senco pneumatic fasteners. The plastic trigger is used to actuate the trigger valve assembly when firing the fasteners. This trigger is available as an individual replacement part, please see model diagram for associative parts.

This part is sourced from the original equipment manufacturer for Senco nailers. The ratchet spring applies tension on the connected components. It is an identical replacement for a faulty or a missing hardware that was installed on a new unit. Please make sure to refer to the diagrams for your model for the correct location and applicati...Read moreon of this part. This high-quality spring is made of durable metal and is sold individually.