SNS40 Senco Nailer - Overview

This is a genuine Senco replacement part, it is sold individually. Its purpose is to retain or secure the Retaining Pins in the Senco models below. It is attached to the pins by pressing them on the beveled end of the pins.

This is an authentic replacement part that is supplied directly from the original equipment manufacturer for use with Senco nailers. It is the special component which helps to provide an air-tight seal for the valve assembly, over time it may wear out and begin to crack eventually requiring a replacement. Please note this durable rubber seal is sold individually.

This is an authentic replacement part manufactured for use with Senco pneumatic nailers and staplers. The special spring is commonly used to provide resistance for the single sequential type of trigger assembly. This spring is available as an individual replacement part.

This spring is an OEM part direct from Senco. The metal spring is compatible with several nailer devices, and is sold individually. This component provides the necessary resistance in the trigger. Pliers and a hex key are often required for the installation.

The part is an OEM from the Senco manufacturer. The plastic seal is made for use with several nailer devices. This item is fitted onto the valve assembly, providing protection from friction. A hex key is required for the installation. The seal is sold individually.

This pin is made OEM to fit the Senco tools listed below. It is used to secure trigger and safety element/guide to a nailer's main body. It is held in place by o-ring retainer # KC0062. This small pin is essential to the operation of these tools but is easily lost or broken; having a backup is a good idea. Sold individually.

This is an original Senco replacement part manufactured for use with pneumatic nailers and staplers. Seals can become pitted, become flat, or just wear out over time. Replacing worn seals is part of maintaining nail and staple guns. This seal is used to seal the cylinder and the body of the gun, the seal is sold individually.

It is a high quality OEM sourced replacement part that is specially produced for use with Senco staplers and nailers. This is the seal for the valve assembly, please make sure to check appropriate diagrams for correct location and application of this item. One durable rubber seal is included per order.

This is an authentic replacement part manufactured for Senco pneumatic fasteners. The plastic trigger is used to actuate the trigger valve assembly when firing the fasteners. This trigger is available as an individual replacement part, please see model diagram for associative parts.

Genuine Senco replacement part, this part is sold individually. The purpose of this part is to create a seal so air does not leak from the gun. When replacing this Seal it is advised to inspect all of the other Seals and O-Rings for wear.