Models
>
S-CV-43
S-CV-43 Southland Tiller - Overview
Sections of the S-CV-43
[Viewing 7 of 7]Keep searches simple, eg. "belt" or "pump".
Recoil Starter Assembly
PartSelect #: PS10041100
Manufacturer #: A200783
This recoil starter assembly is supplied by the original manufacturer for use in tillers. It includes a plastic starter housing, metal mounting plate, starter pulley with recoil springs, grip handle, ...
$32.99
In Stock
Throttle Trigger & Cable
PartSelect #: PS10041055
Manufacturer #: A200738
This OEM plastic throttle trigger and rubber-insulated cable in your lawn equipment control the fuel and air flow to the engine, determining its speed and power. They are typically located on the hand...
$44.86
In Stock
Kit, Internal Filter, Pre-Filter
PartSelect #: PS17016766
Manufacturer #: A203643
Kit, Internal Filter, Pre-Filter
$12.99
In Stock
Fuel Line Filter Assembly
PartSelect #: PS17016767
Manufacturer #: A203641
Fuel Line Filter Assembly
$21.36
In Stock
Drag Stake
PartSelect #: PS10041062
Manufacturer #: A200745
This drag stake, also known as a drag bar or drag shoe, is a genuine OEM replacement part used in tillers and cultivators. It is a metal bar with a pointed end, measuring 7 3/4 inches in length and 1 ...
$7.51
In Stock
Questions And Answers for S-CV-43
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the S-CV-43
[Viewing 1 of 1]Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Fuel tank cracked from winter cold, created a large hole.
It was as simple as removing four (4) hex screws holding the gas tank to the tiller frame. Once the tank was removed, took a screwdriver to pry the fuel line from the old tank (being careful not to damage the rubber seals). Place fuel line (there is another short line attached to it), I call it a breather line.Once in, attach fuel tank to
... Read more
tiller frame. Prime and start. This is super easy.
TIP: When placing the lines in the new tank, ensure you have the small and the large line in the same position as it came off the old tank, as the small must marry up with the small line and the larger one with the larger one.
TIP: When placing the lines in the new tank, ensure you have the small and the large line in the same position as it came off the old tank, as the small must marry up with the small line and the larger one with the larger one.
Read less
Parts Used:
-
Rogers from SAN ANTONIO, TX
-
Difficulty Level:Very Easy
-
Total Repair Time:15 - 30 mins
3 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Pull rope broke and starter cup spring lost
I follow a guy on YouTube alot of good videos on how to replace.
Parts Used:
-
Keith from MAGNOLIA, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers, Socket set
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!