RY43160A Ryobi Pole Saw - Overview

This part is the replacement chain for your pole saw. It is made of metal and is sold individually. The chain rotates around the bar to help the pole saw cut properly. If the chain is damaged or missing teeth, it may not cut evenly, or at all, and will need to be replaced. This is an authentic OEM part sourced directly from the manufacturer.

This is a genuine OEM replacement part, it is sold individually. The purpose of the 3290875G Retaining Ring is to attach and hold the washer and sprocket to the driveshaft on the models shown below. To remove this part it is best to use retaining ring pliers (or snap ring pliers).

This is a genuine OEM replacement part, it is sold individually. The purpose of this washer is to act as a spacer between the chain sprocket and as a friction barrier on the chainsaw models shown below. This is a wear part that we send out quite often. It is advised to order an extra one or two to keep on hand.

This is a Genuine Manufacturer Approved replacement kit used on certain Electric Pole Saws. This kit includes all metal parts: Adjustment Screw, Retaining Pin, Adjustment Bar/Plate. Chainsaw chains stretch and become loose during operation. Saw chain tension should be checked and tightened often. If the chain is too tight, not only will i...Read moret rob the saw's engine of power due to increased friction, but the chain also runs the risk of breaking. If the chain is too loose, it can come off the bar and seriously injure the operator.

This is a manufacturer approved replacement part designed for use with Ryobi pole saw. Bar holds the cutting chain in place. If it is bent or worn out, causing the chain to not cut properly the bar should be replaced. It is made out of metal and it is sold individually. You would need a screwdriver a wrench set to replace this part. • ...Read more Remove the housing • Release the chain tension • Remove the chain and the tensioner • Remove the bar and replace it with a new one • Secure the tensioner and the chain • Reassemble the housing and tighten the chain

This manufacturer approved replacement part is designed for use with electric pole saws. This assembly includes a metal brush holder, one (1) carbon brush with a lead wire and a spring attached. Due to constant contact with an armature brushes will eventually wear down and will need to be replaced. It is advised to replace both brushes a...Read moret the same type. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems. You would need a screwdriver to complete this job. • Remove the screws from the housing • Separate housing to gain access to armature and brushes • Remove old brush assembly and replace it with a new one • Re-assemble and test the tool

This genuine manufacturer sourced replacement part designed for use with pole saws. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt. It is used to secure the chain cover assembly. This lock nut is made out of metal and it is sold individually.

This item has been OEM sourced to ensure a high level of quality. The power cord is intended to be used with pole saws and hedge trimmers from Homelite and Ryobi. The two wire cord includes the cord protector and is encased in a durable jacket. This item is used to relay electricity from an extension cord to the switch assembly. The cord is priced as a single item.

This part does not come with a carbon brush anymore.

The chain cover attaches to the bar and is made out of a hard plastic. This item is available as an individual replacement part. This is a replacement part directly sourced from the manufacturer for use in electric pole saws made by Homelite and Ryobi. During the replacement of this part, a screwdriver and a wrench set may be needed.

This oil filler cap is specially designed for use with pole saws. It is used to keep the oil in the tank. A damaged or lost filler cap should be replaced before the unit can be operated. It is made out of yellow plastic and it is sold individually.