RY1418MT Ryobi Pressure Washer - Overview

This is a genuine OEM replacement part for Homelite and Ryobi pressure washers. The switch is used to turn the machine on and off. This is a complete switch which is located inside of the motor housing. This is made of plastic and metal components and is sold as an individual replacement part.

This is a genuine Ryobi replacement high pressure hose that is supplied directly from original equipment manufacturer. It is specially designed for use with pressure washers. This high pressure hose is made out of rubber/plastic material. It is 25 ft long and it is sold individually. This hose can be used on pumps that produce up to 1700 PSI.

This replacement spray wand is specially made for use with Ryobi pressure washers. It is supplied directly from original manufacturer and it is sold individually. This items connects to the pistol/gun and allows user to connect nozzles to change spray patterns. This is a commonly replaced part due to regular wear, damage or if it is lost. Replacing a wand is easy and does not require any tools.

This is an authentic manufacturer made replacement part which is specially designed for use with Ryobi pressure washers. The detergent tank cap seals the detergent tank to ensure the soap stays contained as well as keep debris from getting in the tank. The cap is made of plastic and is sold individually. No tools are required for installation, simply screw on the cap firmly to the detergent tank to secure.

This is an authentic OEM part designed to be used on the Ryobi pressure washers listed below. This very low pressure nozzle is designed to draw soap/chemical mixture from the detergent tank, and spray it onto surfaces for cleaning. It is usually called a soap nozzle but can also known as a chemical injector tip. Includes one (1) nozzle.

This authentic OEM trigger handle is specially designed for use with pressure washers. It allows the user to control the pressure and flow of water during use. It has an ergonomically designed grip allowing for easy and longer handling. When the pull lever/trigger mechanism is squeezed, it activates the pump, and pressurized water is rele...Read moreased through the nozzle. However, if the trigger handle is loose or damaged you will notice water leakage, loss of pressure, weak flow, or no flow at all. A damaged trigger may also cause water to flow continuously leading to wastage and potential safety hazards. Turn off the water supply, and disconnect the washer from power before beginning this repair. Remove the trigger handle from the holder at the end of the pressure washer wand and check the area for any clogs or damage. Place the new handle onto the holder and ensure it is securely fitted before restoring the water supply.