RY09973 Ryobi Leaf Blower / Vacuum - Overview

The OEM Air Filter is used to stop debris and particles from entering the carburetor and engine, which could cause damage. It is attached in the air filter housing. It comes in black, and is contructed from foam. Installation is rated as "Easy" by customers, and will require a screwdriver. (Tip: You can place the filter in a plastic bag w...Read moreith a bit of oil, remove it, and then squeeze the filter to drain the excess oil. The remaining oil will work as a sticky trap). If the part becomes worn over time, the engine will be hard to start and will run rich. In this case, replace the part. Refer to your make, model and diagram to ensure this is the correct part for you.

This is a genuine OEM replacement part, it is sold individually. The Bellows is attaches to the elbow coming off the blower. It is then followed by Straight Upper Tube, then the Lower Tube. Its propose is to provide some flexibility for the tubes while using the blower.

Genuine OEM replacement part, this item is sold individually. This Fuel Cap is is on the fuel tank on the outdoor products shown below. This is a vented Fuel Cap. It includes a gasket inside the Cap.

This is an OEM replacement part,it is sold individually. The purpose of the Air Purge Bulb is to purge all of the air from the carburetor. It then brings fuel up through the fuel line in the tank into the carburetor. Once the carburetor is full of fuel the Bulb will force the excess fuel back into the tank through the fuel return line. ...Read moreOver time the bulb will loose it elasticity or begin to crack, it will need to be replaced at this time.

It is a genuine OEM approved component that is specially made for use with handheld lawn and garden equipment. The purpose of this clip is to secure the fuel line, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Unfortunately, over time parts may wear out, get ...Read moredamaged or simply lost eventually requiring a replacement. Please note this high-quality clip is made of durable metal and is sold individually.

This is an authentic OEM sourced component which is specially designed for Ryobi, Homelite and Toro lawn and garden equipment. It is an identical replacement for a missing or a faulty clip that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application ...Read moreof this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

This replacement starter housing assembly is an authentic OEM sourced item that is specially designed for use on handheld lawn and garden equipment. It is the assembly that allows user to pull-start the unit. It includes the plastic housing, starter pulley, recoil spring, plastic grip and the pull rope. Please note the hardware to secure this starter assembly is sold separately.

This piston ring is a high-quality manufacturer sourced replacement part that is specially designed for use with gas powered handheld lawn and garden equipment. It is utilized to provide an air-tight seal between the piston and the cylinder walls, over time it will wear out eventually requiring a replacement to maintain peak performance. ...Read morePlease note this high-quality piston ring is made of durable metal and it is sold individually.

This is an authentic OEM strap produced by the original manufacturer for backpack blowers. A waist strap is a load-bearing strap used to distribute the pack's weight over the whole body rather than just the shoulders. This black fabric strap includes a plastic buckle fastener and plastic slide adjusters. This part connects onto the frame. Note that harness, straps and back pad are sold separately.

This is an authentic replacement screw which is supplied by the original equipment manufacturer for use with handheld lawn and garden equipment. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams for correct location and use of this item. This high-quality Torx screw is made of durable metal and it is sold individually.