RUD8000RQ0 Roper Dishwasher Parts & Repair Help | PartSelect
Models > RUD8000RQ0

RUD8000RQ0 Roper Dishwasher - Overview

Manuals & Care Guides for RUD8000RQ0

Click to download
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
(45)
PartSelect #:PS11745451
Manufacturer #:WP8268655
This is a replacement upper dish rack wheel with mount for your dishwasher. The mount supports the dish rack, and the wheel allows the rack to slide out easily. To replace this par...
$25.83
In Stock
(48)
PartSelect #:PS11722146
Manufacturer #:W10083957V
This is a chopper assembly or drain food chopper, and it is designed for your dishwasher. The chopper chops up/minces the food particles in your dishwasher to prevent them from clo...
$29.35
On Order
(11)
PartSelect #:PS11745496
Manufacturer #:WP8269145
The mounting bracket is sold individually, without screws. This part secures the upper side of the dishwasher to the underside of the counter or cabinet to prevent the dishwasher f...
$16.27
In Stock
(59)
PartSelect #:PS8260087
Manufacturer #:W10518394
The heating element is used to create heat during the dry cycle and increase water temperature during portions of the wash cycle when certain options are selected. If your dishes a...
$68.18
On Order
(42)
PartSelect #:PS5136129
Manufacturer #:W10542314
This one-piece door gasket provides a water tight seal between the tub and the door, to keep water from leaking out of your dishwasher. If your dishwasher is leaking, tears, or the...
$75.26
On Order
(35)
PartSelect #:PS11746591
Manufacturer #:WP8565925
The rack track stop on your dishwasher is designed to stop the dish rack at the appropriate place when opening and closing the rack. If your dishwasher is not cleaning your dishes ...
$5.51
On Order
(40)
PartSelect #:PS11746426
Manufacturer #:WP8558307
The rinse aid cap (sometimes referred to as the dispenser cap), covers the rinse aid dispenser on the dishwasher door. If your dishwasher will not dispense detergent, or it is leak...
$21.26
In Stock
(18)
PartSelect #:PS774514
Manufacturer #:8193762
When replacing these fuses the wire harness must be replaced as well. It is located in the control panel. The harness is included with this part now.
$27.33
In Stock
(22)
PartSelect #:PS972316
Manufacturer #:8193983
This is also called the 3rd-level spinner. This part works like a little spray arm at the top of your dishwasher.
$29.35
In Stock
(23)
PartSelect #:PS11746408
Manufacturer #:WP8558129
This part releases the detergent and rinse aid into the dishwasher.
$74.62
In Stock
Questions and Answers for RUD8000RQ0
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dishes on top rack of dishwasher were not being cleaned.

  • Customer: Bill from North Richland Hills, TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers
  • 328 of 349 people found this instruction helpful
1) Remove top and bottom dish baskets from the dishwasher, this will give you room to work. To remove top basket there are clips at the end of the slide rails.
2) Remove lower spray arm by unscrewing plastic screw, it should only be hand tight.
3) In order to remove the strainer cover, you will need to remove the plastic tube that takes water to th... read more

Loud grinding noise from water pump

  • Customer: Steve from Inver Grove Heights, MN
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
  • 208 of 224 people found this instruction helpful
Rather than remove the pump assembly - as an earlier post had done - I pulled the entire dishwasher out and laid it down on the floor. This allowed easy, direct access to the motor (that was the hard, messy part). From this point it was easy. Unplug the wiring, remove the retaining bolt, rotate the motor off the mounting brackets and pull it out. Then put th... read more

Heater element broken.

  • Customer: Dennis from Sedro Woolley, WA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Wrench set
  • 181 of 195 people found this instruction helpful
Step 1: Remove the screws in the bottom of the countertop.

Step 2: Remove the screws holding the bottom kickplate.

Step 3: Loosen leveling legs.

Step 4: Pull dishwasher out of hole.

Step 5: Unlplug dishwasher.

Step 6: Disconnect wires from bottom of element in back.

Step 7: Remove plastic nuts... read more