RP1800 Makita Router - Overview

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

This cord is a genuine Makita replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Over time, power tool cords will wear out or become frayed. We recommend replacing a cord as soon as signs of wear are visible. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 8 Feet Long

Set of 2 Carbon Brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. This brush set will fit the Makita tools listed at the bottom of the page. • Worn brushes are frequently the cause of a poorly running motor. • Replacing brushes can fi...Read morex an intermittently operating motor. • New brushes can restore a motor's electric braking. Carbon motor brushes are one of the most commonly replaced power tool parts. The reason is that carbon brushes are wear items, meaning that through friction and use they will gradually wear away and eventually will need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, also check your armature for burns, cracks, or other damage which are indications of a larger motor problem needing attention.

This cord guard / strain reliever is a genuine Makita replacement part. It covers the final portion of cord before entering the tool, providing extra rigidness and preventing cord damage. Over time these cord guards break down and require replacement. The guard is constructed of heavy duty rubber compound for toughness. This cord guar...Read mored is compatible with the tools listed below. It is not guaranteed to fit any other power tool models.

This is a genuine OEM sourced replacement collet insert adapter specially designed for use with Makita routers. This part will allow for use of 1/4" bits. Due to prolonged, heavy use a collet adapter may begin to wear out requiring replacement. It is made out of metal and is sold individually. To replace this item you will need a wrench....Read more • First you would need to remove the collet nut • Once the nut is removed you can remove the old collet adapter • Place a new one in place • Tighten the collet nut back in place and your unit is ready to use 1/4" bits

This pan head screw is an authentic replacement part. It is sourced directly from original equipment manufacturer for use with Makita power tools. This standard hardware is used in different locations depending on equipment. To ensure correct application please make sure to check appropriate diagrams. Includes one (1) metal screw. You will need a torx or a flat-head screwdriver to tighten or loosen this screw.

The compression spring connects to the pin. It is made of metal and is sold individually. This is an OEM part sourced directly from the manufacturer and used in Makita saws. A set of pliers might be necessary during the installation of this item. This part will need to be replaced if it breaks or bends.

Genuine Makita replacement part. This pan-head phillips screw includes a washer. It is sold individually.