This gas burner grate is used for some gas ranges and cooktops. This is a black burner grate with each side measuring almost eight inches. This part may become rusted or burnt over time if not properly taken care of or with excessive use. If you notice that your grate is discolored or blackening, it may need to be replaced. The surface bu...Read morerner grate provides a steady surface for your cookware that is placed on top of the surface burner. This is a genuine OEM part that is sourced directly from the manufacturer.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
There was a crack in the porcelain not letting it spark
23 of 36 peoplefound this instruction helpful.
Billy from Martinsville, IN
Really Easy
Less than 15 mins
Screw drivers
I used a screwdriver to pry the electrode assy. out of the burner. then disconnected the wire. Then just connected the new electrode and place the assy, in the burner.
Was this helpful?
Thank you for voting!
Stove Work But Your Oven Won't Get Hot ?
16 of 19 peoplefound this instruction helpful.
Brian from Cumming, GA
Really Easy
15 - 30 mins
Screw drivers
If your stove work's but your oven won't get hot it is your ignigter the ignighter in proper working condition sends a signal to the gas valve saying let the gas flow its ok. When the ignighter quits working it won't let the gas flow and your oven will not get hot. It is an easy fix. Just pull out all of interior parts the racks and th
... Read moree bottom heat shield the ignighter the white stone looking part that is screwed to the burner with two wires and it really don't matter what way the wires go back one of the wires connects in the back so you will have to pull the oven out. Now you have to clean under it and your done.
Read less
Was this helpful?
Thank you for voting!
broken ignitor insulation; repeated sparking after burner lit
15 of 21 peoplefound this instruction helpful.
Joe from San Bruno, CA
A Bit Difficult
30 - 60 mins
Nutdriver, Screw drivers, Wrench (Adjustable)
Disconnected gas & electric connections; lifted unit out of countertop onto padded table upside down. Unscrewed ~16 sheet metal screws for access. Removed bad ignitor by driving off retaining clip. Had to remove burner (3 screws) for access to install retaining clip on new ignitor. Reassembled, reinstalled. Works like new!