RGT350UD (P1131465N D) Amana Cooktop - Overview

Diagrams for RGT350UD

See every part. Know exactly what you need.

Parts for the RGT350UD

Spark Electrode

★★★★★

(3)

Part #WP3185804

This part helps your burner ignite and produce flame.

$11.77

Refrigerator Screw

Part #WP8281227

This screw is sold individually.

CLIP, ELECTRODE *

Part #Y07714200

This clip is well under an inch in diameter. It is made of metal and it will help secure a range's electrode.

DISCONTINUED

Part #314638B

Burner Cap - Small

Part #314637B

Spark Module

Part #WPY705823

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

SPARK SWITCH

Part #Y0302242

DISCONTINUED

Part #31750420

SPARK SWITCH

Part #Y0304121

GRATE TOP BURNER

Part #305478B

DISCONTINUED

Part #31789101

HARNESS, H.V. MOD TO BURNER

Part #Y0304288

Common Symptoms of the RGT350UD

How this model fails, and the parts that fix it.

Will Not Start

Fixed by
these parts

Show All

Gas igniter glows, but will not light

Fixed by
these parts

Show All

Element will not heat

Fixed by
these parts

Show All

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

There was a crack in the porcelain not letting it spark

23 of 36 people found this instruction helpful.

Billy from Martinsville, IN
Really Easy
Less than 15 mins
Screw drivers

I used a screwdriver to pry the electrode assy. out of the burner. then disconnected the wire.
Then just connected the new electrode and place the assy, in the burner.

Was this helpful?

broken ignitor insulation; repeated sparking after burner lit

15 of 21 people found this instruction helpful.

Joe from San Bruno, CA
A Bit Difficult
30 - 60 mins
Nutdriver, Screw drivers, Wrench (Adjustable)

Disconnected gas & electric connections; lifted unit out of countertop onto padded table upside down. Unscrewed ~16 sheet metal screws for access. Removed bad ignitor by driving off retaining clip. Had to remove burner (3 screws) for access to install retaining clip on new ignitor. Reassembled, reinstalled. Works like new!

Was this helpful?

Spark Ignition Electrode was not sparking properly

5 of 10 people found this instruction helpful.

Wade from Jacksons Gap, AL
Easy
Less than 15 mins
Pliers

Used a pair of pliers and pulled firmly on ignit. elect. till the retaining clip pulled off the bottom of the elect.The wire pulled off the bottom of it and I had to use a long- thin- nose set of needlenose pliers to pull the wire out of where the elect. came out.Plugged wire in place and snapped electrode back in place without using the ... Read more

Read less

Was this helpful?