RFC1500AAW Admiral Freezer - Parts

This capacitor (Refrigerator and Freezer Compressor Run Capacitor, Run Capacitor) provides the voltage or energy current required to start the compressor and keep it running. It allows the compressor in your appliance to easily cycle on and off. This capacitor mounts directly onto the compressor starting relay. If the capacitor is faulty ...Read morethe compressor may get unusually hot and draw excessive amperage. It the compressor overheats, it may fail to run until it cools down again. The compressor may also get noisy from overheating. If this part is totally electrically open, it is defective (often due to overheating) and needs to be replaced. The part measures 1 inch by 1-1/2 inches, and is constructed of plastic with two metal wire terminals. This item includes 1 capacitor, sold individually. This part comes in black.

This light bulb is a 120 volt, 25 watt incandescent appliance light bulb with a small base screw-in that fits in a variety of appliances such as microwaves, refrigerators, freezers, cooktops, or stoves. Its purpose is to light up the appliance when the door is open. This is a genuine OEM part. You may need to replace the light bulb if the...Read more existing bulb is burnt out or broken. This light bulb is sold individually and is a common wear part, it is recommended to order a spare.

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

This door key is a part for your chest-style freezer door handle. Your freezer will have a lid that locks and unlocks, and the function of this door key is to engage and disengage this lock. The measurements of this part are roughly 2 inches long, and 1 inch wide. If your key is lost or damaged, this is the OEM replacement part you will n...Read moreeed. We recommend that when you receive your key, you test it on your lock to ensure that the locking mechanism is working. Also, be careful to store your key in a safe place away from the freezer.

Keep cold air contained with a replacement freezer door or lid gasket. A damaged seal can allow moisture inside, leading to frost, temperature changes, and longer cooling cycles. First, clean the existing gasket and cabinet edge, then check for gaps or hardened sections. Make sure the lid is aligned correctly because loose hinges can also...Read more prevent a proper seal. Verify compatibility using the full appliance model before purchase. Disconnect electrical power before replacement. If the new gasket arrives folded, soften it with warm water or gentle heat. Avoid overheating the material. Install it evenly, close the lid, and inspect the entire seal for gaps.

This drier may also be known as a refrigerator ultra-violet dye drier or a filter drier and is meant to be used with your fridge. This piece is a filter for the refrigerant that moves through the refrigerators sealed-system. The most common reason you will need to replace the filter is if your fridge/freezer is not starting. You should co...Read morensider having this piece installed by an appliance repair technician that is trained and licensed. Installing this part requires specialized knowledge and tools. The installation will require the service technician to recover and recharge the refrigerant in the refrigerators sealed-system.

This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. ***NOTE: This part needs to be installed by a trained professional in appliance repair. It requires special tools and knowledge to do so.

This part maintains the proper temperature. When the refrigerator reaches the desired temperature, this part interrupts the flow of electricity to the compressor which stops the cooling process.

This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. ***NOTE: This part needs to be installed by a trained professional in appliance repair. It requires special tools and knowledge to do so.

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.