R4030S Ridgid Tile Saw - Overview

Genuine Manufacturer Approved replacement part used on a variety of Power Tools. This Ball Bearing has multiple applications depending on your tool. This part is made out of Metal and it is Sold Individually. Ball Bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the wei...Read moreght evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement. To replace this Bearing you would need a Screwdriver and a Set of Wrenches.

It is a high-quality component which is designed for use with Ridgid tile saws. The part is supplied directly from the original equipment manufacturer. This is one of the special guide rollers that allow table assembly to move back and forth on the rails. Unfortunately, over time the part may wear out, get damaged or even lost eventually ...Read morerequiring a replacement to maintain a properly functioning equipment. It is made of durable plastic material and is sold as an individual component. Note, the hardware to secure it is not included and is sold separately. To replace it, you will need a properly sized wrench.

This is a genuine OEM sourced replacement part designed for use with Ridgid tile saws. This assembly includes one (1) carbon brush with a lead wire and a spring attached. Please note brush holder is sold separately. Carbon brushes are a commonly replaced part on power tools. Due to normal use and friction brushes will gradually wear down...Read more and will require replacement. It is advised to replace both brushes at the same type. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • First remove brush caps • Take out old brushes and replace them with new ones • Secure brush caps

The knuckle lock knob attaches to the support bracket. This item is priced individually and is a genuine Ridgid replacement part for tile saws. It is made out of metal and will require replacing if it becomes broken. A screwdriver and wrench may be needed during the replacement of this part.