R2850 Ridgid Multi-Tool - Overview

It is an authentic manufacturer sourced replacement brush holder that is specially designed for Ridgid saws. The purpose of this part is to hold carbon brushes around the armature to provide stable and safe contact. This high quality brush holder is sold individually, please note carbon brushes are sold separately.

This manufacturer sourced replacement part designed for use on Ridgid power tools. The purpose of the brush cap is to hold the brush in the tool. This cap has external threads that thread into the housing of the tool. Be careful when removing and replacing these, they have a tendency to break. This item is made out of plastic and it is so...Read moreld individually. You would need a flathead screwdriver to install or remove this brush cap.

The o-ring goes between the transmission shaft and the washer. This part is an OEM from Ridgid and Ryobi for use in circular saws, grinders, reciprocating saws, and routers. It is made of rubber and is sold individually. It might require a screwdriver to replace this item. This part may become broken and will need to be replaced.

This is genuine replacement carbon brush designed for use with Ridgid jobmax power handle. This assembly includes one (1) carbon brush with a lead wire and a spring attached. Carbon brushes are commonly replaced items on power tools. Due to constant contact with an armature, over time they will gradually wear down requiring replacement. ...Read moreIt is advised to replace both brushes at the same type. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • Remove the brush cap and take out the old brush • Secure the new brush with a cap and test the tool

This genuine OEM sourced replacement ball bearing is a standard item which has multiple uses on a variety of power tools. Please check diagrams for proper application of this item. The bearing is specially designed to reduce friction between rotating parts. Over time it will wear out, at this point it should be replaced. This is a sealed metal bearing and it is sold individually.

This is a genuine manufacturer approved replacement part designed for use with power handles. This is the gear cap for the motor. It is made out of rubber and it is sold individually. To complete this repair you would need a screwdriver.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with attachment power handles and drills from Ridgid and Ryobi. The torx head screw is commonly used to fasten the two halves of the motor housing assembly. This screw is sold as an individual replacement part, please note the amount needed may vary based on the model of the tool.