This is the replacement charcoal filter for your microwave. It is silver and black in color and measures approximately 10 inches by 2 ½ inches. The charcoal filter removes cooking odors from the air ...
$22.91
In Stock
Order within the next 6 hrs and your part ships today!
This is a genuine replacement 40 watt bulb for a microwave. The bulb is meant to light up the underside of the microwave or inside of your microwave when the door is open or during use. If your bulb i...
$37.74
In Stock
Order within the next 6 hrs and your part ships today!
This light socket is for your microwave and is designed to hold the light bulb. If the light bulb is not working, and the bulb has not burned out, it may be a problem with the light socket. This part ...
$36.16
In Stock
Order within the next 6 hrs and your part ships today!
Order within the next 6 hrs and your part ships today!
Questions And Answers for PVM9005SJ3SS
Ask our experts a question about this model and we'll get back to you as soon as possible!
12 questions answered by our experts.
Sort by:
< Prev
1
2
3
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Tina
December 27, 2021
The fan will not turn off. It runs non stop
For model number PVM9005SJ3SS
Hello Tina, Thank you for the question. In most cases this is caused by a faulty exhaust fan thermostat. You can test the thermostats with a multi meter to check for continuity. We hope this helps!
What covers need to come off to replace fuse in my ge profile microwave pvm9005sj3ss
For model number PVM9005SJ3SS
Hello Michael, thank you for contacting us. To replace the fuse, you need to unscrew the screws to remove the top outer case of the oven. Replace your fuse, part number PS3486694, in the fuse holder on a small printed circuit board of noise filters which contains capacitors, resistors, and inductors. We hope that helps!
Hello Maxine, Thank you for the question. We suggest checking the Coupler for any damage or wear. If the Coupler is fine, the Turn Table Motor may need to be replaced. We hope this helps!
Open the front cover by pushing it at the top (where it says “Push”), lifting up and pushing back on top edge of the old filter. Pull it out. Installing the new one is basically just the reverse of those steps! That simple.
Old filter did seem to be a little thicker (filter material), but the new one was the exact same dimen
... Read moresions, so it went in properly. Wish the filter material was white, so you knew just how dirty it was actually getting. But... :-D