This is the replacement charcoal filter for your microwave. It is silver and black in color and measures approximately 10 inches by 2 ½ inches. The charcoal filter removes cooking odors from the air ...
$22.91
In Stock
Order within the next 7 hrs and your part ships today!
This is a genuine replacement 40 watt bulb for a microwave. The bulb is meant to light up the underside of the microwave or inside of your microwave when the door is open or during use. If your bulb i...
$37.74
In Stock
Order within the next 7 hrs and your part ships today!
This light socket is for your microwave and is designed to hold the light bulb. If the light bulb is not working, and the bulb has not burned out, it may be a problem with the light socket. This part ...
$36.16
In Stock
Order within the next 7 hrs and your part ships today!
Order within the next 7 hrs and your part ships today!
Questions And Answers for PVM9005SJ2SS
Ask our experts a question about this model and we'll get back to you as soon as possible!
6 questions answered by our experts.
Sort by:
< Prev
1
2
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Craig
February 10, 2020
Digital display will go off and later come back on. Sometimes when cooking it will work normally, other times will cut off and display goes blank again
Hello Craig, Thank you for the question. Normally this is an indication the Main Board PartSelect Number PS11762546 will need to be replaced. We hope this helps.
Most of the control buttons stop working suddenly only few of them still work
Start,cancel 1 minute these are not working only 2 minutes working
For model number PVM9005SJ2SS
Hi Zafer,
Thank you for your question. Try running a hair dryer on low heat over the buttons on the touchpad for a few minutes and press the buttons to see if you can get them to work. if not you will need to replace the control panel assembly. We hope this helps. Thank you and have a great day.
Hi Larry, Thank you for writing. Always unplug your microwave before completing any repairs. Inside the cavity of the appliance there is a cover that unscrews to remove it and expose the Bulb to replace. We hope this helps!
Was this helpful?
Thank you for voting!
STEPHEN
March 2, 2020
The "reset filter" light will not stop blinking no matter how long i hold the button down.
For model number PVM9005SJ2SS
Hello Stephen, thank you for your question. If the charcoal and grease filters were replaced and the light will not stop blinking try resetting the microwave by unplugging or by turning off power at the circuit breaker for 30 seconds or so. I hope this helps.
Was this helpful?
Thank you for voting!
< Prev
1
2
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Open the front cover by pushing it at the top (where it says “Push”), lifting up and pushing back on top edge of the old filter. Pull it out. Installing the new one is basically just the reverse of those steps! That simple.
Old filter did seem to be a little thicker (filter material), but the new one was the exact same dimen
... Read moresions, so it went in properly. Wish the filter material was white, so you knew just how dirty it was actually getting. But... :-D