Unusual noise from an indoor blower can be caused by a worn blower wheel bearing. This replacement bearing provides a smooth support point that allows the wheel to rotate while moving air across the room. Inspect the wheel for cracks, dirt, rubbing marks, or looseness, since these problems can produce similar sounds. Turn off the unit at ...Read morethe breaker and verify that power is disconnected before opening the cabinet. Keep track of screws, clips, and wheel position during removal. Install the bearing in the correct direction, avoid forcing it into place, and spin the wheel by hand to check for rubbing before reassembly.
The fan assembly or condenser fan blade fits on the motor shaft and circulates air over the condenser. This cools the refrigerant before it enters the evaporator. If the fan assembly in your room air conditioner is not operating properly, you will need to replace it with this part. This fan assembly has 5 blades and is approximately 14-1/...Read more2 inches in diameter. It is made of white plastic. You will need to open your air conditioner, and most likely remove it from the wall/window to complete this repair. Be sure to disconnect power to the unit before you begin this repair.
The cross flow fan assembly (or evaporator fan blade) is used to produce an even airflow to keep components from overheating in your air conditioner. If you notice your air conditioner giving off warm air it may be due to the cross flow fan being broken. It can be mounted horizontally or vertically. This part is sold individually and is m...Read moreade of metal. It measures approximately 29 inches long and 4 inches in width. Before working on this part, make sure your house circuit breaker is off and the appliance is unplugged. This is a genuine OEM part that is sourced right from the manufacturer.
This spring clamp is designed for your room air conditioner. This clamp holds the fan blade on the motor shaft so it can rotate during operation. If your fan blade is wobbling on the motor shaft, you may need to replace it. The part is made of metal and is approximately 3/4-inch in diameter. This is an OEM part sourced directly from the m...Read moreanufacturer. This spring clamp is sold individually. Before you begin this repair, make sure your air conditioner is disconnected from the power source. To complete this repair, you will likely need to remove the air conditioning unit from the wall.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Motor mount broke due to imbalance caused by mud dobber nests.
1 personfound this instruction helpful.
Travis from LOUISVILLE, IL
Easy
30 - 60 mins
Nutdriver, Screw drivers
Pulled PTAC out of wall sleeve, unhook wire harness from control area, remove condenser shroud and motor and fan blade all at the same time. Replaced motor bracket and re-installed in reverse order.
Was this helpful?
Thank you for voting!
fan had stripped out and was replacing.
1 of 10 peoplefound this instruction helpful.
Douglas from ENGLEWOOD, TN
Very Difficult
1- 2 hours
Pliers, Screw drivers, Socket set
very tight working situations. made a mistake with a delicate piece of the fan and broke it and that rendered the part unuseful. Since I broke it I considered it to be my fault and just threw it away. Ordered another from another company hoping that just maybe it would be more durable. It arrived in only 4 days. Yours took well over
... Read morea week to arrive. Thanks for asking for my experience.