- Home
- PS968TP2WW
- Instructions
PS968TP2WW General Electric Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Broken drawer support
-
Mario from Deer Park, WA
- Really Easy
- Less than 15 mins
-
Nutdriver
Followed the example picture on the part bag. Anyone could do this, incredibly easy. Took about 4 minutes to install both sides.
Was this helpful?
Thank you for voting!
oven temp. was not what setting called for
-
John from Acme, WA
- Easy
- 1- 2 hours
-
Nutdriver
turned oven off, pulled oven out from wall, removed back of oven, unscrewed sensor from oven replaced with new sensor, put back on, turned power to oven on, tried oven at 425, my temp. gage and the oven temp matched. a very easy fix.
Was this helpful?
Thank you for voting!
Broiler Element burnt out
-
Cherri from Katy, TX
- A Bit Difficult
- 30 - 60 mins
-
Nutdriver
The actual repair was relatively easy but access to the area in the oven made it a little difficult. Just unscrew 5 screws with a nut driver, unplug the old element, plug in the new element and reinstall the 5 screws. The only thing that made this repair difficult was being able to reach the connectors where you plug in the new element.
... Read more
They are loose wire connectors that don't reach very far out of the element receptacle. It was difficult to hold the end of the connector and plug in the new element because the oven door is in your way. Maybe it is easier if you take the oven door off first?
Read less
Was this helpful?
Thank you for voting!
Broil element on top oven was not working
-
andrew from pittstown, NJ
- Easy
- 30 - 60 mins
-
Socket set
Shut the power off at the electric box.Disconnected coil from roof clips.Pulled wire connection from back wall. Disconnected wire clips, connected new unit.Clipped to roof and turned on" Working fine".
Was this helpful?
Thank you for voting!
burner worked on high only
-
Carl from Delray Beach, FL
- Really Easy
- 30 - 60 mins
-
Screw drivers, Socket set
Followed directions from Rodney of Erath La. Directions were perfect and helped me to decide to under take this job. Job took a little longer spending some time to clean the glass top on both sides and around the counter top where it mounts. The actual repair time was quick and easy thanks to Rodney. Price of the part was reasonable an
... Read more
d delivery got here quick. Will deal with parts select again! Carl from Florida
Read less
Was this helpful?
Thank you for voting!
one leg of the terminal block was loose and overheated under load.the terminal block melted and could have caused a fire.
-
brendan from lebanon, NH
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers, Socket set, Wrench set
I took a picture of the setup and damage . I then disconnected the burnt wires and replaced the wires . Then I installed the new terminal block and connected the wires to the proper positions. The reason for the failure was that the delivery people didn't tighten the cord when they installed the stove . I would check the connections per
... Read more
iodically as to avoid another situation like this .
Read less
Was this helpful?
Thank you for voting!