PS906811P-H (090930282) Homelite Generator - Overview

This vapor vent, also known as a vent valve or vent cap, is supplied by the original manufacturer for use with generators. It is designed to provide ventilation for the fuel tank by allowing air to enter and leave the tank as necessary. The vent prevents pressure from building up in the tank and interfering with the flow of fuel. Over tim...Read moree the vent may become clogged, or damaged leading to hard starting, fuel leakage, stalling, and the release of harmful gases into the atmosphere. It is recommended to inspect the vent before each use and replace any blocked vent promptly. To complete this repair, remove the faulty vent from the fuel tank and clean the mounting area. Thread the new vent on to the tank and ensure it is locked in place.

This is an authentic Homelite replacement part. The outlet cover is designed by the manufacturer for use in portable generators. This part is made of flexible rubber, and is attached to the cover plate to protect the duplex receptacle outlets when not in use. You will require a screwdriver when replacing this part. This item is sold individually.

This authentic item is supplied directly from the original equipment manufacturer for use with pressure washers and generators. The wear pad is made of hard rubber and attaches to the foot bracket with a washer and a bolt. It may require a wrench during replacement if the part becomes broken. The pad is sold individually and helps to reduce vibrations and cushion the bracket.

This is a genuine OEM sourced part which is specially made for use with Homelite and Ridgid generators. The switch is an important component that allows a user to turn the equipment on and off, unfortunately, over time parts will wear out and may begin to fail eventually requiring a replacement. Please make sure to check the diagrams of y...Read moreour model for the correct location and application of this part. Keep in mind this high-quality plastic body switch is sold individually.

This is an authentic replacement part, sourced from the original manufacturer for use with generators. This metal washer is commonly used to provide spacing between a bolt and the outside of the foot assembly. The washer is available as an individual replacement part, please note four washers may be required.