Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This is foam tape and it is usually used in conjunction with your range, specifically on the cooktop. Its purpose is to help seal the edges of the cook top to the counter top. Another of its functions...
This part is the replacement fan switch or downdraft vent fan knob for your range hood. It measures approximately 2 inches by 1 inch. The fan switch allows you to turn on the range hood fan when it is...
This bridge heating element kit restores proper heating across the center of compatible cooktops, allowing even cookware heating and expanded cooking space. It is commonly replaced when the bridge ele...
This infinite control switch allows adjustable heat control for a surface burner, providing flexibility across a range of temperature settings. Smooth regulation supports accurate cooking and safe ope...
The GE Infinite Switch is an essential component for cooktops enabling the control of heat levels produced by the element. By expertly toggling the element on and off, it gives you full domination ove...
The controls are on the glasstop and no way to access them from below, so the glass top has to be removed by removing any straps/braces from below and raising the rangetop housing above the counter height.
The foil tape connecting to the downdraft ductwork will need to be removed. Make sure you have foil tape to reseal this co
... Read morennection.
The black foam tape between the cooktop housing and the countertop will need to be separated with a putty knife. Be sure to have the 1/4” low density foam tape on hand for replacement.
Remove the 6 knobs by lifting them upward and then lift the housing above counter height.
The loosened housing can be supported by two pieces of 1x2 that straddle the opening. The sheet metal screws around the perimeter are easily removed and a putty knife under the glass should release the glass. Once the glass is removed, you’ll see an electrical control box with the 6 switches. The fan switch is held in place with two screws. The switch can then be accessed from the side and replaced. Just note the 4 colored wires and move them to the new switch. There’s a 5th contact that’s unused.
Reassembly is straightforward but you’ll need to remove any remaining foam tape, clean the underside and the countertop before applying the new tape.
Could not find any videos thru GE or thru YouTube for a drop in cooktop. After trial and error, found out the following:(1) easier to repair when glass is place down on work area, (2) only remove screws on housing that are closest to glass top. These will allow the glass to come off. The remaining screws hold burner brackets in place.
... Read more (3) burners are held in place by two pins apiece. Further, each pin goes thru a spring which pushes burner flush against glass. By having glass down, it is much easier to position burners and ensure springs stay in place. Finally, when replacing the burner, make sure to put the flanges (thru which pin goes thru) in same places. GE burners have numeric marking at flange positions so this is easy.
