PM-1822 Delta Saw - Overview

Genuine Delta replacement part, this item is sold individually. The purpose of the is nut is to secure the blade of the Table Saw to the Saw Arbor. It is a left hand ACME thread. It is used on all of the right tilting Table Saws listed below.

This special nut is priced individually and fits next to the lock washer. It is made out of metal and will need to be replaced if it becomes stripped or broken. A wrench will be needed during the installation of this part. The nut is an authentic part from Delta to be used in drill presses.

This is a genuine manufacturer sourced replacement part used on Delta and Black and Decker equipment. It helps to distribute the pressure evenly and provide a tight seal between connected components. This is a standard hardware which may have multiple applications. For the exact location please refer to the diagrams of your specific model. This part is made of high-quality metal and is sold individually.

This is an authentic Delta replacement part, sourced from the original manufacturer for use with band saws, drill presses, lathes, table saws, and jointers. The metal key is used to shaft and rotating gear or pulley to allow the two parts to rotate in unison. This item is available as an individual replacement part.

This is an authentic replacement part manufactured for use with Delta arbor saws and table saws. The load spring is commonly used to provide spacing between the arbor bearing and the arbor flange. This load spring is available as an individual replacement part, please see model diagram for associative parts.