Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Barbara
December 26, 2019
Door won’t close & inside light remains on unless held closed. When held closed time set will count down but does not warm food.
For model number PLMV178HCA
Hello Barbara, Thank you for the question. This could be a issue with the Switch assembly that the hooks on the door woudl "hook" into, PartSelect Number PS1532504. I looked up the part and it is listed as No Longer Available/Discontinued sorry. There are no part substitutions listed. My suggestion here would be to call the manufacturer and see if they can provide you with a substitution for these part numbers. We hope this helps!
Purchased an OTR microwave at discount at Lowe's. Display model, so was missing parts. Had to order damper from parts select. I had to moldify the transition part to attatch it to oven. I had to cut the opening, and bend flanges on the sides, and bore holes for screws. Then I had to create templates for attatching the unit to the cab
... Read moreinets and rear wall. After doing that, I turned off the electrical power, and removed the old vent hood. Removed a section of the existing vent pipe, to allow space for the transition unit and elbows. It was necessary to cut a larger opening in the bottom of the cabinet for the new vent and bore holes for the mounting screws. The old hood had a 6" round vent, and the new one is rectangular.After measuring and locating studs in the back wall, I secured the holding bracket to the wall, using long wood screws and molly bolts. I hooked the bracket into the bottom of the oven, and tilted it into place, inserting the attatching screws through the holes in the cabinet bottom into the threaded holes in the oven. After tightening the screws, checking for level, I attatched the transition unit to the vent opening above the damper. I then attached the transition unit to the existing vent pipe, installed a junction box with grounded outlet to the existing wiring. [The original unit was directly wired into the electrical circuit--the OTR unit has a plug on a power cord]. Restored power, tested unit, and all worked well.
