PK5011CX1 Makita Sander - Overview

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

Included in Part Number 516306-1. rnThis Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls re...Read moreduces friction. This reduces wear on the tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Set of 2 Carbon Brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. This brush set will fit the Makita tools listed at the bottom of the page. • Worn brushes frequently are the cause behind a motor running poorly. • Replacing brushes ...Read morecan fix a motor that's operating intermittently. • New brushes can restore a motor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Genuine Makita replacement part, this part is sold individually. This screw is used to secure various internal and external parts in the tool models shown below.It is a metric screw sized M4 X 16 (W, SW).

This is an authentic Makita replacement part manufactured for use with angle grinders and circular saws. The sealed bearing is used to reduce friction between a rotating shaft and fixed housing or assembly. This bearing is often used to allow the spindle to rotate inside the gear box, but may have other uses. Please see model diagram for part location and usage. This bearing is sold individually.

This is an authentic OEM part. The Makita compression spring 7 is made for use with several router and grinder devices. The metal spring is often fitted in the motor bracket, providing tension to the pin. This component is sold individually. Please refer to the specific manual for repair instructions. No tools should be necessary for making the installation.

Genuine Makita replacement part. This Hex socket bolt includes a washer and is sold individually.

This an authentic Makita replacement part sourced from the original manufacturer for use with power tools. The metal nut is used with several different types of power tools and the application of the nut can vary based on the model of the power tool. This nut is available as an individual replacement part, please see model diagram for associative parts.

This authentic retaining ring is supplied by the original equipment manufacturer for use with Makita power tools. It is an identical replacement for a damaged or a missing hardware that was installed on a new unit. Check the diagrams for your model to ensure the exact location and the correct application of this part. Keep in mind this hi...Read moregh-quality retaining ring is made of durable metal and is sold individually. You will snap-ring pliers to secure or remove it.