PGP7030SL3SS General Electric Range - Instructions

Purchased another Cooktop Control Knob assembly and pulled the old knob off carefully and replaced with the new Control Knob Assembly. It was very easy and quick ! Thanks FB

The following are steps in replacing a burner electrode for GE Profile Cook Top Model PGP7030DL1BB
1. Shut off gas and unplug electrical plug
2. Remove all stove grates and turn on knobs
3. Remove all burner covers
4. Remove all screws [three for each burner]
5. Remove two screws near front by removing rubber gra ... Read more te grommets
6. Carefully Lift off stove cover and set aside
7. Remove shield near back of stove top. This exposes all burner wires
8. Remove electrode to burner which does not lite by sliding out clip at bottom of electrode—note color code of wire and replace with same. Change one electrode at a time to insure wire color code is correct.
9. Reassemble in reverse order of steps 1-8

HAVE A NICE DAY

So for years have been struggling with this burner. Technicians could not figure out the problem. Then one day, I noticed that the top cover did not sit properly on the burner. Lifted up the burner with the cover on it and noticed that the burner itself was warped and deformed. The top cover never sat evenly on the burner. Ordered a ... Read more new burner and put it in and presto. The burner work properly for the first time since we bought the stove. So, check the burners and see if the top cover sits evenly on the burner.

The knobs arrived beautifully packed and fit perfectly. They needed replaced because I had put old ones in top rack of dishwasher and the finish, which is some kind of foil like paper, peeled off. I have always put knobs in dishwasher and never had a problem