Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Bottom portion of range would not heat up.
1 of 3 peoplefound this instruction helpful.
Patricia from WESTERVILLE, OH
Really Easy
30 - 60 mins
Called sears
Was this helpful?
Thank you for voting!
Oven Sensor Replacement
Barbara from Edwardsville, IL
A Bit Difficult
30 - 60 mins
Nutdriver
The part was just like the old one and would have been an easy fix except our range suffered from a lighting hit. The clips had melted together. Called a dealer and asked about a new wiring harness. He said in those cases just cut the clip off and hard wire with wire clips,or firecrackers. We used wire nuts and taped all together and
... Read morethe oven works just great. Nothing is ever as easy as it should be.
Read less
Was this helpful?
Thank you for voting!
Hot Spot On Burner
Arthur from Riverside, RI
Really Easy
Less than 15 mins
Replaced old burner element with new, easy
Was this helpful?
Thank you for voting!
Replace medium burner for gas cooktop
Charles from Houston, TX
Really Easy
Less than 15 mins
Very easy to remove grates, burner cover and remove old burner head. Very simple process, but surprised that there was no efficient way to clean carbon deposits from my old burner. Burner video instructions on line insured I installed the new burner head correctly (actually, pretty hard to get wrong), and burner worked correctly immediate
... Read morely. Will likely replace other burners in time as the new one is so "silvery" colored compared to my other burners.
Read less
Was this helpful?
Thank you for voting!
Burner would not ignite.
John from Los Angeles, CA
Really Easy
Less than 15 mins
Could not have been simpler. Burner head dropped into place and was held in place by gravity. Not possible for part to go in incorrectly.
Was this helpful?
Thank you for voting!
needed to unstall "anti tilt" bracket on back of electric range to be code compliant for property..
Greg from Ft. Washington, PA
Really Easy
Less than 15 mins
Screw drivers
Turned off circuit breaker, Then pulled out range, straight out and away from wall and cabinets. Layed braket on flooring and moved stove back in to make certain it aligned with range rear stands. Moved range back out, marked holes in braket, screwed in screws to anchor bracket. Pushed range back into placed against wall. Tried to |"til
... Read moret" range by pulling down on door after opened - range was held in place sre
uneven flame and sputtered, burner was not useable
glen from felch, MI
Really Easy
Less than 15 mins
Simple to correct 1. lift off grate 2. lift off burner cover 3. lift off old burner. 4. replace burner, cover and grate. took 10 seconds. burner works perfect
Was this helpful?
Thank you for voting!
oven continued to get F2, F3 and F5 error messages when ovewn got hot
Ralph from Redding, CA
Difficult
1- 2 hours
Nutdriver, Screw drivers, Socket set
This repair was quite a bit more difficult then what had been described on the web site. First off, I have a double wall oven that is built in. Sliding it out of the cabinet was difficult and because oven was hard wired, I had to disconnect the actual wiring from the oven back. . Positioning the oven and allowing for it to rest on a s
... Read moreupport bench was the most difficult part The oven is heavy. Eventually, removing the back and top panels of the oven revealed the sensor connection. I was then able to feed it through the oven and reconnect all the wiring harnesses.. Getting the oven back in the cabinet was equally a challenge. But it did seem to fix the problem with over heating.
My Orders
