My Orders
- Home
- PB915ST2SS
- Instructions
PB915ST2SS General Electric Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
F2 reading
-
lynn from sunnyside, NY
- Really Easy
- 15 - 30 mins
-
Nutdriver, Pliers
Followed the instructions that were sent to me by E-Mail.
Was this helpful?
Thank you for voting!
Dual Burner was not turning off or turning on by itself
-
Michael from North Miami Beach, FL
- Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
Pulled the top back panel off, pulled off burner control knob, removed 2 screws which released switch, removed 5 wires from switch and connected them to new switch (pulled off faily easily). Reconnected the 2 screws to range and pushed knob back on. Replaced panel and reconnect the electric. Now works as it should.
Was this helpful?
Thank you for voting!
one leg of the terminal block was loose and overheated under load.the terminal block melted and could have caused a fire.
-
brendan from lebanon, NH
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers, Socket set, Wrench set
I took a picture of the setup and damage . I then disconnected the burnt wires and replaced the wires . Then I installed the new terminal block and connected the wires to the proper positions. The reason for the failure was that the delivery people didn't tighten the cord when they installed the stove . I would check the connections per
... Read more
iodically as to avoid another situation like this .
Read less
Was this helpful?
Thank you for voting!
dead mice in insulation, chewed wire on latch switch
-
Don from Flagstaff, AZ
- A Bit Difficult
- 1- 2 hours
-
Nutdriver, Pliers, Wrench set
replaced insulation
Was this helpful?
Thank you for voting!