P2508 (107717001) Ryobi Pole Saw - Overview

This sprocket is an OEM replacement part for use in chainsaws and pole saws. It is a key component of the chain drive system. The sprocket is a toothed wheel, with a diameter of 1 inch, that is responsible for driving the chain around the bar, allowing it to rotate and cut through materials. It is found at the end of the engine crankshaft...Read more. The sprocket can fail if it is inadequately lubricated, if it impacts a hard object, or if its teeth are worn down. A failed sprocket will cause the chain to move slower, slip, or fail to rotate altogether. You will also notice excessive noise and vibration when using your equipment. Therefore, it is important to replace the sprocket to prevent any additional damage to your equipment. Before you begin, ensure that the chain brake is engaged for your safety. Remove the cover on the chainsaw, and pull out the cutting chain and guide bar. Use a sprocket wrench to remove the old sprocket, position the new sprocket onto the crankshaft and secure it with the retaining nut. Each sold individually.

This retaining ring helps hold a related part in place on compatible chainsaws, pole saws, and trimmers. Replace it if the original ring is lost, bent, or damaged, or if the secured part moves out of position. Remove the battery or disconnect the spark plug wire before repair. Check the exact tool model before ordering.

Rubber seal ring bar oil

This OEM closed-end wire connector is a device that securely joins electrical wires in your lawn equipment. Its outside is made of plastic to insulate the connection, but there is a metal portion in the center that is crimped to hold the wires together. It can be found in different areas depending on the make and model of your machine. If...Read more this connector is broken, you may see damaged or exposed wires and experience unreliable connections. Over time, its crimped connection can get loose. This can lead to improper functioning of your machine and potential safety hazards like electric shocks or fires. To replace the connector, consult your user manual for guidance, locate and access it, then twist or squeeze and pull it away from the wires it is holding. When installing the new connector, do not forget to use a crimper to crimp your wires. Please note that this connector is sold individually.