P2108 (107267001) Ryobi Leaf Blower / Vacuum - Overview

This part is an OEM from Ryobi. The screw (m4 x 14mm bl) is compatible with a variety of lawn and garden tools. The metal screw is often used to help secure the housing assembly. This item is sold individually, and a hex key is required for the installation. It is encouraged to purchase spares, as they can wear over time and regular use.

This authentic OEM fan blade, also known as an impeller or fan wheel, is found within the blower housing. Located near the tail cone assembly and the motor, it creates airflow by spinning rapidly and then expelling it through the nozzle to move leaves and debris. This green replacement fan, with an insert nut, is specifically designed to ...Read morereplace the existing orange fan in your blower. It is made of plastic and should be replaced if it shows signs of cracks, chips, or missing sections. If you notice a decrease in power, it could be an indication of a faulty fan. To replace the blade, gather a screwdriver, pliers, and a T15 driver or bit. Refer to your user guide for detailed instructions. Generally, you will need to remove the screws holding the inlet guard and blower outlet housing, detach them, locate and access the rear shaft of the motor, hold the shaft with pliers, and thread off the old fan assembly. When installing the new assembly, make sure to continue holding the shaft securely while threading it on.

This switch and contact plate assembly, also known as a wiring harness, is sourced from the original manufacturer for use in blowers. The switch controls the flow of electricity to either start or stop the blower, and the contact plate allows for electrical connection. The assembly can fail due to short circuits, faulty wiring, damage, or...Read more normal aging. A faulty switch and contact plate will result in difficulties starting the blower, lack of speed control, and fluctuating power output. Begin the repair by disconnecting the blower from the power source. Remove the blower housing and switch cover to access the assembly. Take note/image of the wire connections for the installation later. Disconnect the wire connectors and carefully pull the faulty assembly out of the blower. Position the new switch and contact plate assembly in the equipment and reconnect the wire connectors to the appropriate terminals using your notes/image from earlier. Reassemble the equipment parts in reverse order.

This OEM closed-end wire connector is a device that securely joins electrical wires in your lawn equipment. Its outside is made of plastic to insulate the connection, but there is a metal portion in the center that is crimped to hold the wires together. It can be found in different areas depending on the make and model of your machine. If...Read more this connector is broken, you may see damaged or exposed wires and experience unreliable connections. Over time, its crimped connection can get loose. This can lead to improper functioning of your machine and potential safety hazards like electric shocks or fires. To replace the connector, consult your user manual for guidance, locate and access it, then twist or squeeze and pull it away from the wires it is holding. When installing the new connector, do not forget to use a crimper to crimp your wires. Please note that this connector is sold individually.

This switch trigger is an OEM part direct from Ryobi. The switch trigger is used to start and stop the motor on a blower. This part is made of a high-quality metal and is sold as an individual replacement part. This will require the use of a screwdriver when replacing.

This is a genuine Ryobi replacement part that has been sourced from the original manufacturer to be used with trimmers, blowers, and edgers. The screw is used with different types of equipment and the application of the screw can vary based on the model of the equipment. This item is sold as a single part.