OD1500LPV5 Rolair Compressor - Overview

This is an authentic Rolair replacement part manufactured for use with air compressors. The regulator is used to adjust the amount of pressure that builds in the tank. This regulator is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine OEM approved replacement part designed for use with Rolair compressors. The pressure switch is a mechanism which communicates to your compressor when to stop and when to start building up pressure. There are multiple reasons a pressure switch could be leaking air. To complete this repair you would need: wrench set, nut ...Read moredriver set and a thread-sealing tape. • Shut off the electricity and drain the air tank • Remove the tank pressure gauge • Remove the pressure switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Install the new pressure switch • Reinstall the safety valve • Connect the wires • Reinstall the pressure switch tube • Screw the pressure gauge onto the new pressure switch and tighten the gauge firmly • Test the air compressor

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Rolair compressors. The safety valve is designed to keep the tank from over-pressurizing, unfortunately, over time it may wear out or get damaged eventually requiring a replacement. Keep in mind this high-quality part is made of durable me...Read moretal and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component.

This is a genuine OEM replacement part made specially for the Rolair machines listed below. It is attached by a screw to the machine's frame. A rubber foot provides stability and dampens vibrations while protecting surfaces below. One (1) rubber foot is included per order. Screw sold separately as part # MIS10093C.

This is an original Rolair replacement part. The straight valve is designed by the manufacturer for use in hand carry compressors. This part is made of brass, and is used to connect the bleeder or discharge tube with the tank. You may require a wrench when replacing this item. This part is sold individually.