This an authentic OEM 40-Watt replacement light bulb, used in a number of household appliances. It is specially designed to withstand extreme temperatures, which is why these replacement bulbs are most often used to light the inside of refrigerators and ranges. It features a standard socket base, which means you simply unscrew the burnt-o...Read moreut bulb and screw in the replacement. Depending on the appliance you may require a screwdriver or nut driver to access the light bulb. We recommend you wear work gloves while handling this replacement part. It is constructed of glass and metal and is sold individually. Depending on the appliance and location of the bulb within it, you may want to consider disconnecting power and using a flashlight for easier access to unscrewing and re-screwing in your bulb during this repair.
This is foam seal for your dryer. It forms a seal to prevent air from escaping the rear of the dryer drum and the lint duct. This model comes with adhesive backing and is located in between the lint chute and the bulkhead of your appliance. This foam seal is just over 28 inches long and under 1 inch wide. You may need to replace this part...Read more if your clothing is taking too long to dry, or if your dryer is not generating enough heat or no heat at all.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Microwave plastic door frame broken
10 of 14 peoplefound this instruction helpful.
Frederic from Los Altos, CA
Really Easy
30 - 60 mins
Screw drivers
Ordered a new door frame morning of March 25. Part arrived the next morning and by that afternoon, the replacement was complete. Only four screws held the frame.
Was this helpful?
Thank you for voting!
Light bulb burned out.
16 of 33 peoplefound this instruction helpful.
Stephen from Cottonwood, AZ
Easy
Less than 15 mins
Screw drivers
Found instruction on internet, 1. Remove anit-tampering screws with punch and hammer 2. Remove the rest of the screws 3. Removed cover 4. Remove burned out bulb and installed new one 5. INstalled cover 6. Installed screws including the anti tampering onces 7. Op tested unit. Wife is happy.
Was this helpful?
Thank you for voting!
Broken Belt on Wave Disperser
8 of 9 peoplefound this instruction helpful.
Harold from Foxfield, CO
Easy
15 - 30 mins
Nutdriver
The microwave is the upper unit of combination microwave & conventional oven. Disconnect power to the unit. Slide unit out of built-in cabinet to expose the top shield of the microwave. Remove 5 screws holding top cover in place. Remove cover, which exposes the belt reel and drive motor. Install the new belt by threading it on the dr
... Read moreive motor pulley, then walk the new belt on the stirrer pulley. Replace the top cover and reinstall the 5 screws. Reinstall the combination unit in the wall cabinet. Reconnect electrical power. Task Complete. The belt just seem to die of old age about every seven year. Without the wave disperser operating, the microwave oven does not give even heating.