If the microwave exhaust fan is not circulating air properly, there could be an issue with the grease filter. A dirty filter will cause your microwave to run less efficiently and can alter the taste o...
$24.24
In Stock
Order within the next 7 hrs and your part ships today!
This high-voltage diode is designed for use within various makes and models of microwaves and is a genuine OEM part that converts alternating current (AC) into direct current (DC). If you notice your ...
$36.25
In Stock
Order within the next 7 hrs and your part ships today!
This is a mounting bracket for a microwave. The part is fitted between your microwave and wall to allows you to secure your appliance safely to the wall studs and install it above your range. It is ma...
This is a micro switch, which is also known as a door switch for your microwave. The main reason for needing to replace this part is if you are not getting heat to your appliance. The door switch is l...
$51.43
In Stock
Order within the next 7 hrs and your part ships today!
This is a high limit thermostat designed for use within various models of microwaves. The purpose of a high limit thermostat is to open the circuit of the appliance when the internal temperature reach...
$36.64
In Stock
Order within the next 7 hrs and your part ships today!
The microwave light, or surface light lens, keeps the bulb in your microwave protected from getting cracked, scratched, and damaged. If your lens is defective or broken, or the bulb in your appliance ...
$38.76
In Stock
Order within the next 7 hrs and your part ships today!
This is the main latch assembly for various models of Samsung microwaves. This assembly is a main component for the door of the microwave that features three switches that detect the door itself and h...
$116.33
In Stock
Order within the next 7 hrs and your part ships today!
Remove the door by lifting up the hinge side so that the two hinge pins disengage from the steel hinge brackets.This can be a bit fiddly so just keep wiggling the door until one of them pops off. Remove the plastic cover trim piece that surrrounds the window, exposing the phillips head screws that secure the door to the handle.
... Read moreRemove the screws to un-install the old handle, they are deep set so if they fall out of the door you will need needle nose pliers to pout them back into the door. Set teh new handle in place and tighten the screws down snuggly. Retrace your steps... snap the plastic trim back in place and reset teh door on it's hinges (once again this can be a bit fiddly so take your time.
Why a tenant would remove and discard the grease filters without replacing them is beyond me! But, I removed the filters from the package and slid them into place. Two minutes tops. I would like to add that I ordered these on Thursday afternoon, and I had them on Saturday; awesome customer service!
I r/r the bulb cover, I then removed the burned out bulbs w/ a rag in case they broke they wouldn't have cut my fingers. You turn the bulbs lefty loosy. Installation is just the reverse. Install each bulb and turn righty titey, just snug the bulbs into place. Replace Glass cover and insert one phillips screw in plate and re-tighten