MBB520 Waring Blender - Overview

This is a genuine manufacturer sourced replacement part used on Waring blenders. The coupling is the part of a blender that transfers power from the blender's motor to the blade assembly. Over time, the teeth on blender coupling wear down until they no longer engage properly on the blade assembly. It is made out of plastic and it is sold individually.

This is a genuine manufacturer approved replacement part designed for use on Waring blenders. This item fills the center hole in the outer lid. It is made out of clear plastic and it is sold individually.

This is a Genuine OEM sourced replacement part designed for use with Waring Blenders. This is the Blade that cuts food inside the container. It is made out of Metal and it is Sold Individually. To replace it you would need a Wrench or Pliers. • First you want to remove the Nut that secures the old blade assembly • Remove the cutte...Read morer assembly and make sure to clean the gaskets • Secure the new blade assembly using the Nut

This is an original Waring replacement part manufactured for use with blenders. This two piece lid includes the round clear plastic center lid which is removable, and the black main lid. The led assembly fits the clover shaped glass blending jars, that are used with several models. This two piece lid is sold individually.

This part is an OEM sourced directly from the manufacturer for use in drink mixers and blenders made by Waring. The brush and spring are made out of metal and plastic. It might require a screwdriver to replace this item if it becomes broken or worn out. This part is available as an individual replacement.

Genuine Waring replacement part, this item is sold individually. This part acts as a seal for the blenders shown below. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then will have to be replaced.

This is an authentic manufacturer sourced replacement part used on Waring blenders. Jar assembly locks into the blender base and holds the foods and liquids being blended. This container is made out of glass and it is sold individually.

This switch is an authentic Waring replacement part and is compatible with blenders. The switch handles the on and off functions of the blender. This part is made of metal and plastic, it is also sold individually. You will need to use a screwdriver to open the cover, but the switch itself just snaps into place once the covers are removed. Be sure to unplug the blender before installation.

This is an authentic Waring replacement part, sourced from the original manufacturer for use with blenders. The special ring fits into the housing between the coupler and the motor and is used to seal the area around the drive shaft. This item is available as an individual replacement part.