LS1219LX Makita Miter Saw - Overview

This power supply cord is a genuine Makita replacement part. It is a high quality item that is specially produced for circular and hypoid saws. It connects to a standard US outlet to supply power to the tool. This rubber insulated cord is sold individually. Please note, cord protector is sold separately. You will need a screwdriver to complete this repair.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out of metal and no tools should be necessary when replacing this item. This is an OEM Makita part directly sourced from the manufacturer for use with saws, cutters, planers, drills, and trimmers.

This is a genuine Makita replacement part that includes two carbon brushes with wire leads attached. Carbon brushes are essential components in power tools and are among the most commonly replaced parts due to regular wear from friction. Over time, worn brushes can cause a motor to run poorly, operate intermittently, or lose electric brak...Read moreing power. Replacing them can often restore your tool’s performance. A worn brush may appear cracked, pitted, burned, or worn down near the wire lead. It’s always best to replace both brushes at the same time, even if only one shows signs of wear. When installing new brushes, be sure to inspect the armature for any damage such as burns or cracks, which could indicate more serious motor issues.

This genuine Makita replacement part is designed for use with a variety of power tools. This screw is a standard hardware which has multiple applications based on your tool. It is made out of metal and it is sold individually. Would require a screwdriver to install or remove this screw.

This replacement pin is an authentic OEM component which is made for use with Makita equipment. The pin is generally utilized to secure a part while allowing it to rotate freely. It is a standard hardware which may have multiple applications. Make sure to refer to the appropriate diagrams of your model for the exact location and the corre...Read morect installation of this pin. One durable metal item is included. You may need a screwdriver to take the unit apart when replacing this pin.

This kerf board is a genuine Makita replacement part, it is not an aftermarket imitation. It is designed for use with 12" compound miter saws. Kerf boards also known as kerf plates are used to prevent splintering of the wood resulting in cleaner cuts. This part is made of rigid plastic and it is sold individually. Screws to secure this keft board are sold separately. You will need a screwdriver to replace this part.

Genuine Makita replacement part, this item is sold individually. The purpose of the Brush Holder Cap is to retain the brush in the brush holder. This Brush Cap is used on all the Makita models listed below. It is removed by using a slotted screwdriver Do not press too hard when removing the cap they do have a tendency to break.

This item is available as an individual replacement part. The strain relief attaches to the gear housing. When replacing this item a screwdriver may be needed. It is made of plastic and will require replacing if it breaks. This is a genuine replacement part sourced from the original manufacturer for use with jointers, planers, and saws made by Makita.