The range thermostat is also commonly known as a stove, oven, cooktop, or range thermal fuse. This thermostat protects your oven from excessive heating, and will shut the oven heat off if excessive heating is detected. This is a genuine part sourced directly from the original manufacturer. You may need to replace this part if your applian...Read morece will not heat properly. It is made of metal and is approximately 1 inch in diameter. This part is sold individually. It is recommended to order a spare, especially if you commonly use the self-cleaning function in your oven.
This temperature sensor, also known as a thermistor, is compatible with various makes and types of appliances. This thermistor uses electrical currents to detect the interior temperature of the appliance it is in and by working with the control board, the board adjusts the level of cooling or heating through its heating or cooling element...Read more, depending on what is needed. If your appliance is being improperly heated or cooled, the temperature sensor may be to blame, and can be tested with a multimeter to check for continuity to see whether it is defective. Check your user manual for exact placement of this thermistor and any diagnostic information.
This is a genuine OEM leveling leg for various models of LG ranges. This leg is used to stabilize and support the range, and if damaged, broken, or missing, will cause your range to rock back and forth. Installing this leg simply requires you to lift on the corner you are installing it under, and then screw it in place until your range is...Read more stable. This approximately 2-inch leveling leg is sold individually, so if your range has multiple legs that are broken or missing, consider how many legs you need to order.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
No heat in oven mode
8 of 11 peoplefound this instruction helpful.
Dennis from CARY, IL
A Bit Difficult
More than 2 hours
Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
Verified P/N with LG. Took a few days . They sent names of several suppliers, cost was almost double. Ordered part from P/S, here in 2 days. Watched video on you tube. Unplugged, took off back, unplugged bake element, removed power box. The opening for bake element is still attached to rear panel by tiny bits of sheet metal. Used Dremel w
... Read moreith cut-off wheel to cut thru nibs & deburr opening. this panel has to be removed, it rests on bottom panel & is held in position by power box. Removed bake element carefully, front of element broken, tried to put new element in, would not fit. Had to grind notches in bottom panel down to clear supports on new element. This did the trick. back together quick & no problems. If had to do again estimate less than 1 hour.. By the way am 81 yrs. young.
Read less
Was this helpful?
Thank you for voting!
wouldn't turn on
2 of 3 peoplefound this instruction helpful.
Michael from MILWAUKEE, WI
Easy
30 - 60 mins
Screw drivers
simply take picture b4 you start then replace same way.
WARNING!!! MAKE SURE YOU HAVE RIGHT PART!! They are very slow to return any type of credit
Was this helpful?
Thank you for voting!
No power to unit after self clean was ran.
1 personfound this instruction helpful.
ROBERT from CHIPPEWA FLS, WI
Easy
30 - 60 mins
Screw drivers
Unscrewed the back panel and Sub assembly then unplugged the board and replugged and put back screws. The ribbon wires were kinda hard to put back in make sure they are in all the way. Check the therm fuse first ( $3.00 fix ) mine was good so next was to try the board.