Quick Question!

Have you ever purchased from PartSelect.com before?

Models > LP6000ER

LP6000ER (AWYAUSL) LG Air Conditioner - Overview

Get Parts and Repair Help for LP6000ER

If you know the air conditioner repair part you need, you can browse the list of all parts on the LP6000ER, or you can search by name or part description. You can also find your part by where it is located on the LP6000ER by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the LP6000ER

[Viewing 1 of 1]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?


This part is a thermistor assembly and it works in conjunction with your room air conditioner. The thermistor is a sensor that attaches to the control board of your air conditioner...



This spring clamp is designed for your room air conditioner. This clamp holds the fan blade on the motor shaft so it can rotate during operation. If your fan blade is wobbling on the motor shaft, you may need to replace it. The part is made of metal and is approximately 3/4-inch in diameter. This is an OEM part sourced directly from the manufacturer. This spring clamp is sold individually. Before you begin this repair, make sure your air conditioner is disconnected from the power source. To complete this repair, you will likely need to remove the air conditioning unit from the wall.

Side Curtain and Frame - Right Side

Also known as an accordion.


PCB Assembly,Display




Curtain Installation Kit

This is used for window air conditioners.


Power Cord Assembly

Remote Controller Assembly


Mechanical Part,Unclassified

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Bad thermistor

  • Customer: Cindy from Baltimore, MD
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Took front cover off air conditioner and pulled it a little forward out of the outdoor housing. I then flipped the LED display section out to the left and exposed the patch panel. The next step was to remove the panel with a small screwdriver and disconnect the old thermistor plug. I then plugged in the new one, remove the old one from the grid bracket and p... read more

Bad thermister, unit would run constantly without cycling.

  • Customer: Gary from Aurora, CO
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Remove the front cover. Slide the unit forward a few inches from the case. Remove 1 screw from the top on the control box. Unsnap the old thermister leads going into the circuit board. Snap in the new thermister and place the end in the plastic holder in front of the coils. Install front cover. read more