LMH-8 Walbro Engine - Overview

It is an authentic manufacturer-sourced replacement gasket which is specially designed for use with Walbro carburetors commonly installed on lawn and garden equipment. This gasket provides an air tight seal for the carburetor, please make sure to check appropriate diagrams of your model for the correct location and use of this hardware. I...Read moret is made of high-quality rubber material and it is sold individually, over time it may wear out and crack eventually requiring a replacement.

This is an authentic Walbro repair kit manufactured for use with carburetors. Old fuel inside a carburetor can oxidize resulting in deposits that can clog the carburetor. A clogged carburetor can be repaired and cleaned rather than replaced. This kit will include parts that should be replaced when rebuilding the carburetor. Some of the pa...Read morerts in the kit are the idle needle, float needle, float support spring, float bowl gasket, throttle shaft spring, float shaft, the mounting gasket, and a few other o-rings and washers. This repair kit is sold as an individual replacement part.

This is an original Walbro replacement part that has been sourced from the manufacturer to be used with small engine carburetors. The metal screws are flanged and used to secure the throttle and choke valves. The valve screw is available as an individual replacement part, please note four screws may be required.

This is a genuine Walbro replacement part. The welch plug is designed by the manufacturer for use in carburetors. This part is made of metal, and is generally used to cover a hole in the device casing. You may require a screwdriver or wrench when replacing this item. This product is sold individually.

This gasket kit is supplied directly from the original equipment manufacturer. The kit includes cardboard composite gaskets, flexible plastic seals and other components. This item is made for use in many carburetor devices. Please refer to specific manual for repair instructions. The gasket kit is sold individually. A screwdriver and a pair of pliers are helpful in making the replacement.

This is an authentic Walbro replacement part manufactured for use with small engine carburetors. The mounting flange gasket is used to seal the connection between the carburetor and the cylinder insulator. This gasket is available as an individual replacement part.