Models
>
LEVM30FE
LEVM30FE Frigidaire Microwave - Overview
Sections of the LEVM30FE
[Viewing 4 of 4]Manuals & Care Guides for LEVM30FE
Click to downloadInstall
Installation Instructions
(3.17MB)
Install
Installation Instructions
(1.72MB)
Manual
Owner's Manuals
(2.1MB)
Manual
Owner's Manuals
(43.34MB)
Wiring
Wiring Diagram
(0.28MB)
Keep searches simple, eg. "belt" or "pump".
Questions And Answers for LEVM30FE
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Sort by:
- < Prev
- 1
- Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Starr
17 days ago
Door above microwave opens and closes constantly even when not operating.
For model number LEVM30FE
Hello Starr, thank you for reaching out. Based on the description that you have provided, we would recommend replacing the door, part number PS1532842, to fix the issue. We hope this solves your problem!
Was this helpful?
Thank you for voting!
Related Parts:
- < Prev
- 1
- Next >
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
changing vent hood to otr microwave
Purchased an OTR microwave at discount at Lowe's. Display model, so was missing parts. Had to order damper from parts select. I had to moldify the transition part to attatch it to oven. I had to cut the opening, and bend flanges on the sides, and bore holes for screws. Then I had to create templates for attatching the unit to the cab
... Read more
inets and rear wall. After doing that, I turned off the electrical power, and removed the old vent hood. Removed a section of the existing vent pipe, to allow space for the transition unit and elbows. It was necessary to cut a larger opening in the bottom of the cabinet for the new vent and bore holes for the mounting screws. The old hood had a 6" round vent, and the new one is rectangular.After measuring and locating studs in the back wall, I secured the holding bracket to the wall, using long wood screws and molly bolts. I hooked the bracket into the bottom of the oven, and tilted it into place, inserting the attatching screws through the holes in the cabinet bottom into the threaded holes in the oven. After tightening the screws, checking for level, I attatched the transition unit to the vent opening above the damper. I then attached the transition unit to the existing vent pipe, installed a junction box with grounded outlet to the existing wiring. [The original unit was directly wired into the electrical circuit--the OTR unit has a plug on a power cord]. Restored power, tested unit, and all worked well.
Read less
Parts Used:
-
GEORGE from SPRING, TX
-
Difficulty Level:Easy
-
Total Repair Time:1- 2 hours
-
Tools:Pliers, Screw drivers
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Unit ran but would not heat food
-
Hector from Semmes, AL
-
Difficulty Level:Easy
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Screw drivers
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!