Models
>
KXW8736YSS0
KXW8736YSS0 KitchenAid Range Hood - Overview
Sections of the KXW8736YSS0
[Viewing 1 of 1]Manuals & Care Guides for KXW8736YSS0
Click to downloadInstall
Installation Instructions
(3.63MB)
Manual
Owner's Manuals
(3.63MB)
Manual
Owner's Manuals
(4.30MB)
Specs
Product Specifications Sheet
(0.09MB)
Keep searches simple, eg. "belt" or "pump".
Range Hood Control Panel
PartSelect #: PS12728687
Manufacturer #: W11387938
The Control panel houses the selection buttons for the range hood.
$132.27
In Stock
Light Bulb
PartSelect #: PS11752134
Manufacturer #: WPW10291579
This OEM light bulb is located in your range hood or vent hood unit. It provides light while you cook on the stovetop. You can determine if the bulb is broken by checking if it does not turn on when y...
$118.74
In Stock
FILTER
PartSelect #: PS3489938
Manufacturer #: W10351890
This part is approximately 13 1/4 inches by 12 1/4 inches.
$100.07
In Stock
Questions And Answers for KXW8736YSS0
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Sort by:
- < Prev
- 1
- Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Geo
July 23, 2021
Fan turned on with lower rpm than usual, ran for a couple of minutes then quits. That phenomenal went on for a few times. The fan died completely now. What repair part(s) do i need? Thank you so much
For model number KXW8736YSS0
Hi Geo,
Thank you for your question. If the fan is no longer working, you will likely need to replace the blower fan motor, but you should also check the control panel and the switches. We hope this helps! If you have any questions, please let us know.
Was this helpful?
Thank you for voting!
Related Parts:
- < Prev
- 1
- Next >
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
one switch went out on the range hood controlling the lights.
The repair did not happen. Parts select sent me the wrong part. They sent a cover plate without any switches.
I;m still waiting for the correct part.!!!!!!!!!!!!!!!!!!!!!!
I;m still waiting for the correct part.!!!!!!!!!!!!!!!!!!!!!!
Parts Used:
-
Jeffrey from MILTON, FL
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Screw drivers
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
SWITCH CONTROL UNIT HAD BROKEN OFF FROM ONE END OF ITS INTERIOR MOUNTING
Removed and cleaned to overhead grease trap filters which required a sink full of detergent some wire wool pads and and much elbow grease. This is probably a service task that should be performed at least annually for hoods in frequent use. And be careful not to cut your fingers on some of the sharp interior edges.
With the g ... Read more rease filters removed it was then possible to access the switch unit from the inside of the hood. Used a small Phillips screwdriver to loosen and remove the two fastening screws and removed and replaces the whole unit.
Refitting was the reverse of the above process.
With the g ... Read more rease filters removed it was then possible to access the switch unit from the inside of the hood. Used a small Phillips screwdriver to loosen and remove the two fastening screws and removed and replaces the whole unit.
Refitting was the reverse of the above process.
Read less
Parts Used:
-
NICHOLAS & LEIGH from CHARLOTTE, NC
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Screw drivers
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Control panel broken
Amazing. PartSelect shipped me the wrong part and then wouldn't refund shipping cost to return it. They need to change their shipping policy as it now states they refund shipping if they were the cause of the mistake.
Parts Used:
-
Brian from LEANDER, TX
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!