This chrome drip pan is designed for gas cooktops and ranges. The pan has an approximate diameter of 8 inches, and the hole in the middle has a diameter of roughly 4 inches. The purpose of this part is to catch the drips and spills coming from the cookware on your stove. Burners are used frequently and these pans can get quite dirty. If y...Read moreours will no longer come clean, or if it is damaged, this is the replacement you need. Before putting the burner head assembly and burner grate back on, make sure the drip pan is flush with the cooktop. When repairing your range or cooktop, make sure it is unplugged and the gas is shut off.
Terminal block kits are also known as terminal boards, or terminal strips, and they are found in a wide variety of household appliances. Most often in ranges, wall ovens, and dryers. This kit attaches the power cord to the inner wiring of your appliance. If the terminal block is faulty, your appliance will not get the power it needs to op...Read moreerate properly. When removing the old block pay close attention to the wire placement, this will make installing your new part much easier. If you notice any of the wires or wire terminals are corroded or damaged they will also need to be replaced.
This is a burner grate for your surface burner, and it is compatible with your range stove top. The purpose of this part is to provide a balanced and stable surface for you to set your cookware on while cooking on your stove. The color of the burner grate is black, and it has a diameter of 6.5 inches. This part is sold individually and in...Read morecludes only one round gas grate per package. The most common reason for needing to replace this part is if your current burner grate has incurred damage from daily usage.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Cord was not tightened enough by delivery crew.
109 of 174 peoplefound this instruction helpful.
Timothy from Spring Valley, AL
Really Easy
15 - 30 mins
Screw drivers, Socket set
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools neede
... Read mored are phillips screwdriver, deep socket for lug nuts. Nut driver optional. Hope this is helpful.
Read less
Was this helpful?
Thank you for voting!
Two top burners would not light, defective switch
12 of 14 peoplefound this instruction helpful.
Donald from Middle Village, NY
Easy
Less than 15 mins
Screw drivers
Warning- we found a lot of bare wires in this stove, check your wires before replacing the bad switches. I lifted the top, disconnected the power, pulled off the knobs, unscrewed the switch for the back light, removed seven screws to finally get the front panel off. Once you have the front panel off, changing the swich takes less than a m
... Read moreinute. The switches just slide off the gas valve stems. Instructions show how to line up the new D-shaped switch mechanism to match the D-shaped shaft. Gently pull the two wires off the old switch and slide onto the new switch. Then put the panel back.
Read less
Was this helpful?
Thank you for voting!
Very old burner grates & drip pans, need replacement.
15 of 23 peoplefound this instruction helpful.
Mariano from Torrance, CA
Really Easy
Less than 15 mins
Took out the old & easily replace it with the new set. No tools required.