KSRG25FKSS17 KitchenAid Refrigerator - Overview

Diagrams for KSRG25FKSS17

See every part. Know exactly what you need.

Parts for the KSRG25FKSS17

$79.33

EveryDrop Water Filter

★★★★★

(53)

Part #EDR5RXD1

Enjoy cleaner water and ice with this easy-to-install refrigerator filter. It uses Triple Filtration Technology to reduce 16 common contaminants, so your drinks and meals taste better. For best results, swap it out every six months to keep your water fresh and safe.

$9.62

Refrigerator Lower Door Closing Cam

★★★★★

(94)

Part #WP2182179

The lower door closing cam is used in refrigerator doors, it can be located on the fresh food side or the freezer side. It helps hold the door open. This cam is made out of plastic, so it might crack or wear down over time. If your door will not open and close properly you may need to replace the door closing cam. To successfully install ...Read more

Read less

$9.62

Refrigerator Door Cam

★★★★★

(73)

Part #WPW10329686

The Door Cam is a black plastic part which helps the door pivot shut while keeping the door and hinge in proper alignment. Lubricating this part upon installation may help it move easier. It attaches onto the door hinge and should be replaced if broken or if there is noticeable damage. Refer to your model number and user manual to ensure...Read more

Read less

$78.77

Water Inlet Valve

★★★★★

(101)

Part #W10408179

The water inlet valve (Refrigerator Water Inlet Valve Kit) provides water for the ice maker and water dispenser. This part is located at the back of the refrigerator, and connects to the water supply. If your water inlet valve is malfunctioning, you could be getting a lack of water to the inside of your refrigerator. Your ice maker may n...Read more

Read less

$120.55

Ice Maker Assembly - 8 Cube

★★★★★

(116)

Part #2198597

This Ice Maker (Icemaker Assembly, Complete Icemaker Assembly, Ice Maker Assembly, Refrigerator Ice Maker) can be used with 25-27 cubic feet refrigerators that have a vertical auger dispenser located on the freezer door. It’s used to make ice. When this part fails, no ice cubes will be made. It could prevent the icemaker from filling with...Read more

Read less

$70.95

Icemaker Control Assembly

★★★★★

(31)

Part #W10190935

The “Icemaker Control Assembly” (Module & Motor Assembly, Ice Maker Control Module, Icemaker Module, Refrigerator Ice Maker Module) is what controls the actions of your ice maker. The control turns the timing cams and the ejector blades. It controls most of the basic parts and functions such as the heater, water inlet valve, the cube size...Read more

Read less

$17.15

Refrigerator Control Bracket

★★★★★

(128)

Part #WP2180226

This is a control bracket for your refrigerator, and may also be known as the dispenser control bracket. The function of this part is to hold the micro switches and the light socket in the freezer dispenser section in place. Its measurements are roughly 9 inches long and 5 inches high, and this model comes in white. The tools you will nee...Read more

Read less

$17.15

Refrigerator Ice Guide

★★★★★

(63)

Part #WP2180224

This is a refrigerator ice guide that is made entirely of clear plastic. This ice guide is located in the freezer door. Turn your refrigerator ice dispenser off before replacing the part. This is a simple repair, and the only tool you will need is a small flat blade screwdriver to push on the pivot tab on the bottom of the ice guide. Do n...Read more

Read less

$45.29

Refrigerator Capacitor

★★★★★

(44)

Part #WPW10662129

This capacitor (Refrigerator and Freezer Compressor Run Capacitor, Run Capacitor) provides the voltage or energy current required to start the compressor and keep it running. It allows the compressor in your appliance to easily cycle on and off. This capacitor mounts directly onto the compressor starting relay. If the capacitor is faulty ...Read more

Read less

$34.74

Refrigerator Bimetal Defrost Thermostat

★★★★★

(30)

Part #WPW10225581

If you have ice building up in your freezer, or if your freezer is getting too warm during the defrost cycle you may need to replace the bi-metal defrost thermostat. The function of the defrost bi-metal thermostat is to clip onto the evaporator and protect your evaporator from overheating during the defrost cycle. If your refrigerator doe...Read more

Read less

$37.91

Refrigerator Dispenser Overflow Grille

★★★★★

(25)

Part #WP2206670B

This grille is located on the bottom of the ice/water dispenser to catch the overflow. (Black)

Ice Door Kit

★★★★★

(44)

Part #W10823377

In this kit you will find the support, the ice door, spring, and delay. The heater ribbon is no longer needed and therefore will not be included with this part. This kit works in the dispenser chute to let ice through when it is being dispensed. If you have the following symptoms such as: door sweating, difficulty opening or closing door,...Read more

Read less

Manuals & Care Guides for KSRG25FKSS17

Click to download

Questions And Answers for KSRG25FKSS17

Ask our experts a question about this model and we'll get back to you as soon as possible!

Sort by:

Don - For model number KSRG25FKSS17

December 7, 2023

Do you sell replacement compressors for this unit? OR Since it is 18 years old should i buy a new fridge?

Hi Don, Thank you for your question. The compressor is replaceable. The part number for the compressor kit is PS2580805. We hope this helps!

$410.79

Compressor Kit

Was this helpful?

Dominick - For model number KSRG25FKSS17

July 28, 2026

Water drips from bottle filler

Hello Dominick, thank you for contacting us. Dispense water continuously for 5 seconds, pause for 5 seconds, and repeat until approximately 2 to 3 gallons have been dispensed. This clears air pockets from the reservoir and lines that expand under pressure and push water out of the nozzle after dispensing stops. If the dripping continues after purging, check the water filter. Remove it and reinstall firmly until it clicks fully into place. If the drip persists after addressing the filter and air, the water inlet valve is likely not sealing completely. A worn solenoid or mineral buildup prevents the valve from fully closing, causing a steady drip through the dispenser. The replacement water inlet valve assembly is part number PS3497634. Glad to be of assistance!

$78.77

Water Inlet Valve

Was this helpful?

Common Symptoms of the KSRG25FKSS17

How this model fails, and the parts that fix it.